Dell IDRAC6 Configuring Ipmi Using Web Interface, Click System→ Alerts→ Email Alert Settings

3Click System→ Alerts→ Email Alert Settings.

4In the Destination Email Addresses table, do the following to configure a destination address for the Email Alert Number:

a Select or clear the State checkbox. A selected checkbox indicates that the email address is enabled to receive the alerts. A clear checkbox indicates that the email address is disabled for receiving alert messages.

b In the Destination E-mail Address field, type a valid e-mail address. c In the E-mail Description field, type a short description.

5In Test Email, click Send to test the configured e-mail alert settings.

6In the SMTP (e-mail) Server IP Address field, enter a valid SMTP IP address.

NOTE: To successfully send a test e-mail, the SMTP (email) Server

IP Address must be configured on the Email Alert Settings page. The SMTP Server uses the set IP address to communicate with the iDRAC6 to send e-mail alerts when a platform event occurs.

7Click Apply. The settings are saved.

Configuring IPMI Using Web Interface

1Log in to the remote system using a supported Web browser.

2Configure IPMI over LAN.

a In the System tree, click Remote Access.

b Click the Network/Security tab and click Network.

c In the Network page under IPMI Settings, select Enable IPMI Over LAN and click Apply.

d Update the IPMI LAN channel privileges, if required.

NOTE: This setting determines the IPMI commands that can be executed from the IPMI over LAN interface. For more information, see the IPMI 2.0 specifications.

Under IPMI Settings, click the Channel Privilege Level Limit drop- down menu, select Administrator, Operator, or User and click Apply.

eSet the IPMI LAN channel encryption key, if required.

NOTE: iDRAC6 IPMI supports the RMCP+ protocol.

Configuring the iDRAC6 Using the Web Interface

61