Bolens MTD warranty Auger Belt Replacement

Page 17

1	Auger Belt Replacement
1	To remove and replace your snow thrower’s auger belt,
	proceed as follows:
	1.	Remove the plastic belt cover on the front of the
		engine by removing the two self-tapping screws.
	NOTE: Drain the gasoline from the snow thrower, or
	place a piece of plastic under the gas cap.
	2.	Carefully pivot the snow thrower up and forward so
		that it rests on the auger housing. Remove the frame
		cover from the underside of the snow thrower by
		removing four self-tapping screws which secure it.
	3.	Roll the auger belt off the engine pulley.
	4. a. Loosen and remove the shoulder screw which
2		acts as a belt keeper.
2		b. Unhook the support bracket spring from the
		frame.
	5. Remove the belt from around the auger pulley, and
		slip the belt between the support bracket and the
		auger pulley. Reassemble auger belt by following
		instructions in reverse order.
	NOTE: Do NOT forget to reinstall the shoulder screw
	and reconnect the spring to the frame after installing
	a replacement auger belt and to remove the piece of
	plastic from under the gas cap.

3

4	5
�

�

6

Maintaining

Your Snow

Thrower

NOTE: Although multi-viscosity oils (5W30, 10W30 etc.) improve starting in cold weather, these multi- viscosity oils also result in higher oil consump- tion when used above 32ºF (0ºC). Check your snow thrower’s engine oil level more frequently to avoid possible engine damage from running low on oil.

NOTE: Do not sand- blast spark plug. Spark plug should be cleaned by scraping or wire brushing and washing with a commercial solvent.

IMPORTANT NEVER replace the auger shear pins with standard pins. Any damage to the auger gearbox or other com- ponents, as a result of doing so, will NOT be covered by your snow thrower’s warranty.

17

Image 17

Contents Two-Stage Snow Thrower OPERATOR’S ManualCustomer Support Table of ContentsFinding and Recording Model Number Your Responsibility Restrict the use Chute Clean-out ToolSafe Operation Do not modify engine OperationTighten hand knobs securing upper handle to lower handle Setting Up Your Snow ThrowerTest on Prior to operatingInstructions care Shear Pin StorageAll models Drift Cutters If EquippedClean-Out Tool Clean-Out ToolSkid Shoes Tire Pressure Pneumatic TiresKnow Your Snow Thrower Drive Control/ Auger Control Lock Auger ControlFour-Way Chute Control Ignition KeyStarting The Engine Electric Starter on certain modelsElectric Starter on certain models Recoil StarterAuger Control Test Recoil StarterShift Cable Making AdjustmentsChute Control Drive Control & Shift LeverReversible Skid Shoe Standard Skid ShoeShave Plate and Skid Shoes EngineLubrication Auger Belt Replacement Drive Belt Replacement Friction Wheel Removal Wipe equipment with an oiled rag to prevent rust Off-Season StorageProblem Cause Remedy TWO Year Supreme Warranty Part Description RÉF Pièce 17 9 Part Description RÉF Pièce 2112 23 14 5952 Carter de la collet avec trou pour raccord de graissage Page 31A-6006 Roue Jante Batterie la sur jours dix-vingt-quatre de complète Garantie Accidentel ouDépannage Solution Causes ProblèmeCarburant le Videz Gaz Propre etSouffleuse Hex boulons des par Dégât Tout .ordinairesTarières des lement Suit comme procédez caoutchoucTransmission De courroie la de Remplacement’essence Tarière la de courroie la de Remplacement’essence bouchon ’oubliez VidezMoteur Patins et plate LameLubriﬁcation Réglages Tarière la de CommandePatins Réversible Patin 16B Figure Ordinaire Patin 16A FigureVitesses de levier Et transmission la de CommandeGoulotte la de Commande Lanceur à Démarreur Électrique démarreur le d’utiliser Modèles certains sur électrique DémarreurAvant instructions les toutes sement Soigneu Suivez .conducteur le blesser’huile Plein Faites Ne Soufﬂeuse la de CommandesDépart de Volet Pneus des Pression Général d’ordre RecommandationsGoulotte la de dégagement de Outil Pièce CetteStock en disponibilité la et prix les concernant gnement Échéant cas le coupe de BarresDe goupille la de Remisage Cisaillement’assemblage Après .ESSENCE Sans mais d’huile plein Employer à moteur à l’huile à et carburant auQuant moteur du d’utilisation notice la consulter veuillez Sécurité de Consignes Votre UtilisationGoulotte la ed Dégagement De Outil Responsabilité VotreGoulotte la de dégagement deUnoutil Modèle de numéro le trouver Pour Vente-après ServiceMatières des Table Modèle le sur série de numéro le et modèle de numéro le772C0774 Phases deux neige à Soufﬂeuse15/2005