Maintenance Instructions

OPERATING INSTRUCTIONS

REMOVING THE Jet Cleaner FROM THE POOL

Upon completion of the Jet Cleaner’s cleaning cycle (When the pool is clean), turn off the power supply by pressin the ON/OFF switch to the OFF position.

Unplug the Jet Cleaner’s Floating Cable from the Power Supply

Gently pull the Jet Cleaner toward you using the Floating Cable. When the Jet Cleaner is within reach, grab its handle and release the floating cable. Removing the Jet Cleaner by its Floating Cable may cause severe damage to the cable.

Remove the Jet Cleaner from the water using its handle.

Rest the Jet Cleaner on its side to allow water to drain from the unit.

IN-SEASON STORAGE

Never leave your Jet Cleaner in the pool when not in use. Do Not allow swimmers in the pool while in use.

After removing your Jet Cleaner from the pool you should clean and re-install the filter bag. Then rest the Jet Cleaner on its side in a dry, shaded area along with its Power Supply and properly coiled Floating Cable.

OFF-SEASON STORAGE

When the Pool Season is over you should thoroughly clean both filter bags, make sure that there is no

water in the Jet Cleaner, completely untangle and then properly coil the Floating Cable. Your Jet Cleaner and Power Supply should be stored in a dry, protected area.

Remove the Jet Cleaner from the water. NOTE: Make sure that the Power Supply is turned off and that the Jet Cleaner’s Floating Cable is unplugged.

Place the Jet Cleaner on its back and release the four Lock Tabs to unlock the Bottom Lid Assembly. Remove the Bottom Lid Assembly. (FIG. 3)

Remove the bag clips and the Filter Bag from the bag support wire frames (FIG. 5).

Turn the Filter Bag inside out (the Fine Filter Bag has a soft felt surface on the inside) and wash off visible dirt using a garden hose or a faucet. Gently agitate the bag in your hands to help remove fine particles. Continue cleaning and squeezing the bag gently until rinse water is clear. Use of a washing machine (gentle cycle) is recommended when visible dirt will not rinse off by other methods. USE NO DETERGENT or BLEACH! DO NOT MACHINE DRY!

Turn the Filter Bag "right side out" (felt surface on the inside) re-mount the bag on the wire frames making sure that the label on the bag is centered on one of the long sides of the Bottom Lid Assembly (directly beneath one of the V’s in the wire frames. Pull the bag toward the middle of each wire frames so that the bag corners are snug against the corners of the wire frame. Tuck the excess bag into the V-shaped section of the wire frames (FIG.4). Replace the Bag Clips.

Re-install the Bottom lid Assembly. Make sure that neither debris nor the Filter Bag itself interferes with complete closure of the Bottom Lid Assembly.

FIG.3

FIG.4

FIG.5

Bag clips

Label

Lock Tabs