AQUATECH Swimming Pool Cleaner Other Cleaning Patterns, Adjusting the Jet Cleaner for Your Pool

CLEANING PATTERNS

FIG.9

OTHER CLEANING PATTERNS

If you feel that the Jet Cleaner is not cleaning your entire pool, you may wish to make one of the following adjustments to its cleaning pattern:

SETTING THE CLEANING PATTERN FOR YOUR POOL

Your Jet Cleaner is pre-set to scan and clean most pools 70 to 80 feet (20 to 24 meters) in length. The Jet Cleaner is factory set to look like the picture in Fig. 9 with one Lock pin installed on each side. The Jet Cleaner will systematically clean your pool in a consistent pattern.

After your Jet Cleaner completes its cleaning cycle remove the Jet Cleaner from the pool and transfer the Lock pins from the right side of the unit to the left side(vice versa). Next time you use your Jet Cleaner the cleaning unit will clean the pool in the opposite pattern. This will ensure that your cleaner completely cleans your entire pool.

Lock Pin

FIG.10

ADJUSTING THE Jet Cleaner FOR YOUR POOL

The Jet Cleaner uses a systematic cleaning pattern that allows the cleaner to go back and fourth in overlapping patterns. The Jet Cleaner may be used to clean a variety of different size pools, from the small, to the very large. Before its first use, you must set up the Jet Cleaner for your pool. To adjust the Jet Cleaner you will use the axle locking pin. (Fig. 10). There are two locking pins permanently attached to the unit with a lanyard. Only one locking pin is required for most applications. For the very large pools you will need to install an additional locking pin (Located on the jet valve housing). Follow the pin configuration illustration for your size pool (Fig. 11).

6