Pentair Quasar owner manual Section VI. Storage and Winterizing Instructions

Page 10

8. Thread the bulb assembly nut until it just touches the fitting body, then finger tighten.

CAUTION

Do not over tighten as adjustability of flow director may be impaired and/or damage to parts causing leakage may occur. If low director does not rotate by hand, nut is too tight.

9.Take the red cap/plug off and gently bring the wire connectors through the back side of the bulb assembly. Save red cap/plug for storage and winterizing.

10.Connect the wire connectors from the bulb assembly to the wire connectors attached to the snap-on cord cap.

NOTE

There is no polarity (no positive or negative) to the wires, either connection will work.

11. Snap cap onto end of body and turn so that the electrical cord is pointing down; see Figure 12.

WARNING

Risk of electric shock. Connect only to a circuit protected by a GFCI. Failure to do so can result in death and/or serious injury.

12.Reconnect the power to a circuit in accordance with the appropriate electrical connections. See Sections III and IV, Electrical Connections. If the light is not on, press the switch on the transformer case once.

WARNING

This is an electrical appliance. Unsupervised use of this product by children can result in injury and/or death.

SECTION VI. STORAGE AND WINTERIZING INSTRUCTIONS

1.It is common practice to drain the water level to a point below the skimmer and the light, for winterizing.

2.For storable pools: remove power from the unit by taking the power cords’ three-prong plug and disconnecting it from its electrical outlet.

For permanent pools: turn off all electrical power supplying the light circuit at the main circuit breaker.

3.Remove the snap-on cord cap by inserting a slotted screwdriver into the access hole and prying upwards, as illustrated in Figure 20 in the relamping instructions.

4.The wire connectors should be gently disconnected and pushed into the rear of the bulb assembly.

5.Push red cap/plug into rear of bulb assembly to seal it.

6.Remove the bulb assembly nut.

P/N 98748000

10

REV. F 1-6-05

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Table of Contents Section I. Important Safety Instructions Section II. Lamp Housing InstallationRetain the gaskets supplied and keep them accessible Do not over tighten the flange Section III. Electrical Connections for Storable Pools ¿¿¿WHAT is a GFCI??? Section IV. Electrical Connections for Permanent PoolsRear view of transformer assy Screw Section Relamping Instructions Can result in death or severe personal injurySection VI. Storage and Winterizing Instructions Replacementparts SECTION.VII. TechnicaldataHawkins Ave., Sanford, NC 27330 919

Quasar specifications

Pentair Quasar is an innovative pool and spa filtration system designed to enhance water quality while providing exceptional energy efficiency and ease of use. Known for its advanced engineering and robust features, the Quasar series stands out in the competitive world of pool maintenance.

One of the key features of the Pentair Quasar is its advanced filtration technology, which integrates multi-layer filtration media to effectively capture both large debris and microscopic particles. This results in exceptionally clean water, ensuring that pool owners can enjoy crystal-clear swimming conditions. The multi-layer system minimizes the need for frequent filter changes, thus significantly reducing operational costs and environmental impact.

The Quasar utilizes cutting-edge pump technology, designed to operate efficiently at varying flow rates. This dynamic performance allows for optimal circulation without wasting energy, catering to different pool sizes and requirements. The variable-speed pumps are engineered to deliver silent operation while achieving significant energy savings compared to traditional single-speed pumps. This aligns well with the growing trend towards sustainability in pool management.

Another standout characteristic is its user-friendly control system, which features intuitive touchscreen interfaces that allow for easy adjustments to temperature, filtration schedules, and maintenance alerts. The user-centric design ensures that operators, regardless of experience level, can manage water quality effectively. Moreover, this system can seamlessly integrate with modern smart home technologies, allowing users to monitor and control their pool environment remotely via mobile applications.

The Pentair Quasar also emphasizes durability and reliability. Constructed from high-quality materials resistant to corrosion and UV damage, the system is built to withstand the rigors of outdoor environments. Maintenance is simplified further by design elements that facilitate easy access to internal components, making routine servicing more convenient.

In addition, the Quasar series features advanced water sanitization technologies, including options for salt chlorination systems which promote a more natural swimming experience, free from harsh chemicals. This enhances swimmer comfort while maintaining the highest water sanitation standards.

In summary, the Pentair Quasar represents a leap forward in pool filtration technology. With its multi-layer filtering capabilities, energy-efficient pumps, intuitive control systems, and enhanced durability, it offers an optimal solution for homeowners looking to maintain pristine pool conditions with minimal effort and environmental impact. The Quasar is a testament to Pentair's commitment to innovation in water technology, making it a preferred choice for discerning pool enthusiasts.
Top Page Image Contents