•During night time pool use, artificial lighting shall be used to illuminate all safety signs, ladders, steps, deck surfaces and walks.
•The installer shall follow written instructions provided for operation of the circulation system.
•Decks shell meet local codes and comply with
•Underwater lights having front access shall be installed and removed only with use of tools.
•The installer of the vinyl liner shall affix on the original or replacement liner, or on the pool structure, all safety signs in accordance with the manufacturer’s instructions. The safety signs shall be placed above the water line.
All components such as the filtration system, pumps and heater shall be positioned so as to prevent their being used as a means of access to the pool by young children.
INTRODUCTION
The installation of an average size pool (12' - 30' diameter) will usually require three people to help set it up. Listed is an assortment of tools and materials which you will need for preparing the ground, checking the levelness, and setting up the pool.
SELECTING POOL LOCATION
The selection and preparation of the pool site is your responsibility. The manufacturer can only suggest the proper techniques, indicate the important considerations and emphasize the precautions, and cannot be held responsible for damages to your pool that may result from failure to carefully follow all pool site specifications.
1.The surface on which your pool will stand must be ABSOLUTELY LEVEL AND SOLID. This condition should extend one (1) foot beyond the actual pool area all around. The best surface is bare solid earth free from stones, roots, and other sharp objects.
2.Allow plenty of play area around the pool. Fit the location into your landscaping plans.
3.The pool site must be accessible to electrical and water supply and should allow for disposal of great quantities of water when pool is drained.
4.When installing your pool on a SOLID LEVEL SURFACE, it is imperative that you protect your pool and liner from chemicals and other foreign
matter contained in the surface. Protect your pool and liner by inserting between them and the surface any material that is not made from a tar derivative or con- tains sharp twigs, etc. We suggest the use of a plastic ground shield to be used between the surface and the pool liner (See
step 2). Do not install your pool on peat moss, tar paper, gravel or chemically treated soil not approved for pool use. Any or all of these surfaces can ruin your pool and liner and will void your warranty.
5.Do not set up your pool under trees or under overhead wires.
6.DO NOT set up your pool near any existing structure such as your house garage, etc., as this condition will induce diving or jumping into your pool which could result in permanent injury or death.
7.Do not set up your pool on or near any septic system or underground utilities.
8.Choose your pool location convenient for:
a.Connecting electrical wires of your accessories (filter, heater, lights) to your electrical outlets conforming to electrical codes.
b.Draining large amounts of water.
Screwdriver
Hammer
Tape
| Hoe |
| Knife |
| Rake |
Shovel | 4” Nail |
|
Broom
Pliers
Patio Blocks
Carpenters
Level
Cloth Tape
2 x 4
Center
Stake
Sifted Earth
or Pre
Washed
Sand
SOME FRIENDS
TO HELP OUT
3