Graco 1434, 1444, 1452 manual Attaching the Seat Belt, Attaching the Seat Cover, Using the Tray

Page 5

Attaching the Seat Belt

Step 1.

Thread one end of the seat belt through the belt retainer as shown.

Step 2.

Thread both ends of seat belt through the buckles as shown.

CHECK that the belt is threaded correctly by pulling on the seat belt. The belt should not slip through the buckle.

To release, push in on front of buckle.

To Use Head Supports (on certain models)

To provide head support for a smaller child, insert the two head support pads into the pockets located in the back of the cloth seat pad.

Back of cloth seat pad

Attaching the Seat Cover

Step 1.

Slide the pocket of the seat cover over the top of the seat as shown.

Step 2.

Pull the crotch strap and both ends of the seat belt through the slots in the seat cover.

131-6-98 IS2418

9

Step 3.

Push the elastic loop through the hole on one side of seat.

Step 4.

Fold cover around bottom of seat. Then fasten the hook into the elastic loop on one side as shown. Repeat on other side.

CAUTION: Be sure the seat cover at armrest does not interfere with tray latching.

Using the Tray

NOTE: If tray does not latch, check back brace to be sure the word “REAR” is away from the seat.

Step 1.

Unlatch the tray by squeezing the two latches under the tray at the same time, and lift up.

Be careful not to let the tray hit your baby when lifting or closing the tray.

Step 2.

To latch tray, push it down firmly.

Tray must be latched at all times when baby is in swing. Pull up on tray to be sure it is latched.

Reclining Back—

Four Positions

Pull adjustment wire upward and pull seat backward to recline seat. Extra pressure is required to go from the third position to full recline.

For upright position, simply lift back of seat forward.

10

In

S

W th in or th do

S

In th co ru ba

S

To ta sl ho pr he

S

C be

S

O ch as

S

Fa be fit

S

Cl th up

de be Al w tr th

Image 5
Contents Customer Satisfaction Model No , 1444 orCongratulations on your purchase of a Graco swing For future useUlation Hazard Care and MaintenanceAttaching the Feet Attaching the LegsAttaching the Base Tubes StepAttaching the Back Brace Attaching the Hanger Tubes and SeatAttaching the Tray Pull on tray to be sure it is securely attachedAttaching the Seat Belt Using the TrayAttaching the Seat Cover Reclining Back Four PositionsIndicator Light- Red light comes on when swing is turned on Installing the BatteriesStarting the Swing To Use Music on certain modelsParts List Caring for Your Battery Powered SwingReplacement Parts