Assembly

IMPORTANT! Before assembly, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Fisher-Price® for replacement parts and instructions if needed. Never substitute parts.

	Front Legs
	(Longer)
Tapered End
	Press
	Button
	Press
	Button
	Tapered End
1	Front Base

Remote

Holder

Ribbon

•Place the front base on a flat surface.

•Position a front leg (longer) so that the tapered end is downward, as shown.

•While pressing the button on one of the front legs, insert it into the front base. Push down on the front leg until the button “snaps” into the hole in the front base.

•Repeat this procedure to assemble the other front leg to the front base.

Pull Up

Front Legs

Pull Up

2	Front Base

•While standing on the front base, pull the front legs up. The front legs should remain secured to the front base. If you can remove the front legs, you have not assembled them correctly to the front base. Reread and repeat assembly step 1.

•Using scissors, remove the ribbon connecting the remote and the holder.

Holder

Front

Leg Hole

	M4 Lock Nut
	Rounded
	Side
	Shown Actual Size
	Hexagonal Opening
4	M4 Lock Nut
	(Rounded
	Side Out)

•Position the holder so that the open end faces forward, as shown.

•Slide the holder onto the front leg with a hole.

Hint: An M4 lock nut has been assembled to the holder at

the factory. During shipment of this product, it may have fallen out. Check to be sure there is a lock nut in the hexagonal opening on the holder. If it has fallen out, fit the lock nut back into the hexagonal opening. Make sure the rounded side of the lock nut faces out.