Assembly
Seat Wire
Press in Place
Seat Wire is
Through Hole in
Seat Wire Cap
Slots
17
•Lift the seat tubes slightly.
•With the seat wire hanging down, insert the ends of the seat wire through the slots in the seat, as shown.
Rounded Edge Up
Seat Wire
Cap Hole
19 | Seat Wire |
|
Caps |
| |
|
| |
• Press the seat wire caps |
| |
into place. |
| #6 x 5/8" Screw - 4 |
• Insert two #6 x 5/8" screws | Shown Actual Size | |
through each seat wire cap and tighten.
Hint: The seat wire caps are designed to fit into the seat only one way. If the screw holes in the seat wire caps do not align with the holes in the seat, try switching the seat wire caps onto the opposite ends of the seat wire.
Seat Wire
Cap 
| Ends of |
18 | Seat Wire |
Cap | |
| Seat Wire |
Accessory Bin | Accessory Bin |
|
Grooves |
•While holding the seat wire in place, carefully turn the seat around so that the front of the seat faces you.
•Position the seat wire cap so that the rounded edge is upright.
•Fit each end of the seat wire through the hole in each seat wire cap.
20
Seat
#8 x 13/8” Screw - 4
Shown Actual Size
• Turn the seat face down.
•Fit an accessory bin into the groove on each side of the seat, as shown.
•Insert two #8 x 13/8" screws into each accessory bin and tighten.
8