Makita UH4570, UH6570, UH5570 Functional Description, Switch action, Straight cut, Vertical cut

Page 5

11.

Work gloves of stout leather are part of the basic

 

equipment of the hedge trimmer and must always

 

be worn when working with it. Also wear sturdy

 

shoes with anti-skid soles.

12.

Before starting work check to make sure that the

 

trimmer is in good and safe working order. Ensure

 

guards are fitted properly. Check cable for

 

damage before starting work and replace if

 

necessary. The hedge trimmer must not be used

 

unless fully assembled.

FUNCTIONAL DESCRIPTION

CAUTION:

Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool.

Switch action

13.

Keep cable away from the cutting area. Always

 

work in such a way that the extension power cord

 

is behind you.

14.

Remove plug from the mains immediately if cable

 

is damaged or cut.

15.

Make sure you have a secure footing before

 

starting operation.

16.

Hold the tool firmly when using the tool.

17.

Do not operate the tool at no-load unnecessarily.

12

3

009279

1.Switch trigger B

2.Switch trigger A

3.Switch trigger C

18.

Immediately switch off the motor and unplug the

 

mains plug if the cutter should come into contact

 

with a fence or other hard object. Check the cutter

 

for damage, and if damaged repair immediately.

19.

Before checking the cutter, taking care of faults, or

 

removing material caught in the cutter, always

 

switch off the trimmer and unplug the mains plug.

20.

Switch off the trimmer and disconnect and secure

 

the mains plug before doing any maintenance

 

work.

21.

When moving the hedge trimmer to another

 

location, including during work, always unplug the

 

mains plug. Never carry or transport the trimmer

 

with the cutter running. Never grasp the cutter

 

with your hands.

22.

Clean the hedge trimmer and especially the cutter

 

after use, and before putting the trimmer into

 

storage for extended periods. Lightly oil the cutter

 

and put on the cover. The cover supplied with the

 

unit can be hung on the wall, providing a safe and

 

practical way to store the hedge trimmer.

23.

Store the hedge trimmer with the cover on, in a

 

dry room. Keep it out of reach of children. Never

 

store the trimmer outdoors.

SAVE THESE INSTRUCTIONS.

WARNING:

DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury.

For your safety, this tool is equipped with a triple switching system. To turn on the tool, press two out of three triggers A, B and C. Release either one of the two pressed triggers to turn off. The sequence of switching is unimportant as the tool only starts when both switches are activated.

Straight cut

009280

To trim the hedge straight, pull triggers A and B.

Vertical cut

009281

Cut upwards with both hands pull the switch triggers B and C and move it in front of your body.

5

Image 5
Contents Hedge Trimmer EC Declaration of Conformity SpecificationsSymbol General Power Tool Safety Warnings Hedge Trimmer Safety Warnings Functional Description Switch actionStraight cut Vertical cutEngage the extension cord AssemblyWaist cord hook Far area cutOperation Arm cord hook AccessoryInstalling or removing chip receiver accessory Removing or installing shear blade MaintenanceCleaning the tool Blade maintenanceInstalling the shear blade Storage AccessoriesMakita Corporation Anjo, Aichi, Japan