MOUNTING OF HANDLE
–Place the handle with the throttle lever on the handle holder on the right side (to be held by the right hand) and the other on the left side.
–Fit the handle edge to the handle holder groove, and provisionally fix the upper side (3) of the handle holder by four bolts M5 x 25 (4).
–Adjust the handle to an angle easy to manipulate, and tighten the bolt (4) uniformly on the right and left sides.
–Fix the control cable to the shaft by two clips (5).
–Fix the control cable to the handle by clip (6).
–The purpose of the detent lock is to prevent the engine from rotating relative to the drive shaft while operating the starter or transporting the equipment from place to place. The detent should be unlocked while the unit is being used.
12
(4)
(3)
(6)(5)
Hanger
UNLOCK
Detent lock
LOCK