Makita EBH340U instruction manual Mounting of Control Cable, Connection of Switch Cord

Page 13

MOUNTING OF CONTROL CABLE

–Remove the air cleaner cover.

–Place the control cable (1) in the adjusting bolt (2), and shift the swivel (3) so that the cable will be put in the swivel groove. At this time, the round-hole side of the swivel will be oriented toward the inner wire end-metal fitting.

–Release the swivel, and confirm that the inner wire-end metal fitting will be placed in the hole.

–Mount the air cleaner cover.

(2)(3)

(1)

Swivel

Control cable

Insert

Round-hole

End fitting

CONNECTION OF SWITCH CORD

–Connect the switch cords to the two cords from the engine by inserting one into the other.

–Fix the cord connector by clamp (4).

(4)

ADJUSTMENT OF CONTROL CABLE

Adjust the control cable by adjusting bolt so that it will have 1 to 2 mm play when the throttle lever is set to the low-speed position by carburetor adjusting bolt. (Be careful that the cutter blade will not turn in idling.)

13

1-2 mm

Image 13

Contents EBH340U Assembly of engine and shaft Table of ContentsSymbols General Instructions Safety InstructionsIntended use of the machine Personal protective equipmentStarting up the brush cutter Meters RefuellingKickback Method of operationCutting Tools When asking for help, please give the following information Maintenance instructionsNever straighten or weld damaged cutting tools First AidEBH340U Technical DataDesignation of Parts Assembly of Engine and Shaft Mounting of Handle Mounting of Control Cable Connection of Switch CordMounting of Protector Mounting of cutter blade Mounting of Cutter BladeBefore Start of Operation Point 1 in Replacement of Oil Oil GaugeInspection and Refill of Engine Oil If oil adheres around this tip, refill new oilHandling of Fuel Point 2 in Replacement of Oil If oil spills outStorage Period of Fuel FuelCorrect Handling of Machine Points in Operation and HOW to StopStarting Startup after warm-up operation Resharpening the Cutting Tool Adjustment of LOW-SPEED Rotation IdlingStopping Servicing Instructions Replacement of Engine OILPoints on OIL Points in Handling Air Cleaner Element Cleaning of AIR CleanerChecking the Spark Plug Supply of Grease to Gear CaseReplacement of Fuel Pipe Cleaning of Fuel FilterCleaning of Parts Replacement of Gaskets and PackingsStorage Fault location Before After Daily Troubleshooting Immediately Stop engineRun engine at idling Set choke lever To CloseMemo Memo 885002-5