Makita EBH340U instruction manual Startup after warm-up operation

Page 19

3) Primer pump

 

Continue to push the primer pump until fuel enters into

 

the primer pump. (In general, fuel enters into the primer

Carburettor

pump by 7 to 10 pushes.)

 

If the primer pump is pushed excessively, an excess of

 

gasoline returns to the fuel tank.

Primer Pump

 

 

 

4)Recoil starter

Pull the start knob gently until it is hard to pull (compression point). Then, return the start knob, and pull it strongly.

Never pull the rope to the full. Once the start knob is pulled, never release your hand immediately. Hold the start knob until it returns to its original point.

5)Choke lever

When the engine starts, open the choke lever.

Open the choke lever progressively while checking the engine operation. Be sure to open the choke lever to the full in the end.

In cold or when the engine is cooled down, never open the choke lever suddenly. Otherwise, the engine

may stop.

OPEN

6)Warm-up operation

Continue warm-up operation for 2 to 3 minutes.

Note: − If the starter handle is pulled repeatedly when the choke lever remains at “START” position, the engine will not start easily due to excessive fuel intake.

In case of excessive fuel intake, remove the spark plug and pull the starter handle slowly to remove excess fuel. Also, dry the electrode section of the spark plug.

Caution during operation:

If the throttle lever is opened fully in a no-load operation, the engine rotation is increased to 10,000 min-1or more. Never operate the engine at a higher speed than required and at an approximate speed of 6,000 - 8,500 min-1.

B: Startup after warm-up operation

1)Push the primer pump repeatedly.

2)Keep the throttle lever at the idling position. 3￿ Pull the recoil starter strongly.

4)If it is difficult to start the engine, open the throttle by about 1/3. Pay attention to the cutter blade which may rotate.

Attention in Operation

When the engine is operated upside down, white smoke may come out from the muffler.

19

Image 19
Contents EBH340U Assembly of engine and shaft Table of ContentsSymbols Personal protective equipment Safety InstructionsGeneral Instructions Intended use of the machineStarting up the brush cutter Meters RefuellingKickback Method of operationCutting Tools First Aid Maintenance instructionsWhen asking for help, please give the following information Never straighten or weld damaged cutting toolsEBH340U Technical DataDesignation of Parts Assembly of Engine and Shaft Mounting of Handle Mounting of Control Cable Connection of Switch CordMounting of Protector Mounting of cutter blade Mounting of Cutter BladeIf oil adheres around this tip, refill new oil Point 1 in Replacement of Oil Oil GaugeBefore Start of Operation Inspection and Refill of Engine OilFuel Point 2 in Replacement of Oil If oil spills outHandling of Fuel Storage Period of FuelCorrect Handling of Machine Points in Operation and HOW to StopStarting Startup after warm-up operation Resharpening the Cutting Tool Adjustment of LOW-SPEED Rotation IdlingStopping Servicing Instructions Replacement of Engine OILPoints on OIL Supply of Grease to Gear Case Cleaning of AIR CleanerPoints in Handling Air Cleaner Element Checking the Spark PlugReplacement of Gaskets and Packings Cleaning of Fuel FilterReplacement of Fuel Pipe Cleaning of PartsStorage Fault location Before After Daily Troubleshooting Set choke lever To Close Stop engineImmediately Run engine at idlingMemo Memo 885002-5