DIP switch setting
BLANK = UP, X = DOWN
Cartridge 50 100 500 1 k 10 k
Load(ohms)
50000 |
|
|
|
|
8333 |
|
|
| x |
980 |
|
| x |
|
893 |
|
| x | x |
495 |
| x |
|
|
472 |
| x |
| x |
331 |
| x | x |
|
321 |
| x | x | x |
100x
99 | x |
|
| x |
91 | x |
| x |
|
90 | x |
| x | x |
83 | x | x |
|
|
77 | x | x | x |
|
76 | x | x | x | x |
50x
48 | x |
|
| x |
|
47 | x |
|
| x | x |
45 | x |
| x |
|
|
43 | x |
| x | x |
|
33 | x | x |
|
|
|
32 | x | x |
| x |
|
31 | x | x | x |
|
|
30 | x | x | x | x |
|
• Input Panel Connections
The input connection panel includes one pair of RCA type inputs to be used for connection of your
Ground connection is located on the input panel should only be used if necessary. You should first try to hook up your turntable without the use of this grounding plug. In the case that hum is heard through your speakers when the Phono1 is connected, you can easily ground your turntable by connecting the turntable ground to the input panel ground terminal. If grounding your turntable does not alleviate the hum problems, please contact your dealer for further information specific to your system setup.
• RCA Main Output Jacks for Left and Right Channels
These connectors are found on the opposite side as the RCA inputs, ground connector, and loading switches. The Phono1 has one pair of RCA type outputs, which can be run into any input of any preamplifier with RCA type connectors. Do not run the output of your Phono1 into the phono input of another preamplifier. In this case you can use any RCA auxiliary input rather than the phono input.
•Phono1 Placement
The Phono1 may be situated within your
system in any convenient manner desired. The most typical arrangement places the Phono1 near or behind the turntable in order to make the shortest possible connection between the tonearm output and phono stage input. By eliminating as much tonearm interconnect wire as possible you will reduce the system’s susceptibility to RF interference and sonic impact of long wires.
It is recommended to use a high quality type stand or isolation platform capable of dissipating / isolating vibration and resonance.
PHONO Owner's Manual | Page 7 |