Intel 410 manual Completing Your Configuration Setup Under Windows NT

Page 52

Chapter 4. Completing Your Configuration Setup Under Windows NT

7.You now need to reboot your system for changes made thus far to be recognized by Windows NT.

8.After rebooting, you need to perform the steps listed at the beginning of this chapter, Section 4.1.1, Completing a New RAID Array Configuration, in order for the changes to take effect.

9.After completing the steps described in Section 4.1.1, Completing a New RAID Array Configuration, you are done.

4–8	EK–SMRAC–IG. C01

Image 52

Contents Getting Started Third Edition, June Contents Figures Revision Record Page Host Adapter Installation Completing your Configuration Setup under Windows NTAudience Document StructureAppendix a Configuration Record Appendix B Accessing the Command Line Interpreter CLIAssociated Documents ConventionsEK-SMRAC-IG. C01 Pre-installation Steps Installation ChecklistPerform a System Backup Getting Started Page Minimum Installation Clearance Measurements Site PreparationUnpacking the RAID Array 410 SWXRA-Yx Removing the RAID Array 410 from the PalletUnpacking the RAID Array Installing the PC Program Card in the Controller Placing the RAID Array 410 EnclosurePC Program Card Handling Precautions Installing PC Program Card in ControllerConnecting the Controller to Computer PC Program Card Slot LocationStorageWorks Scsi Bus Port and Scsi ID Assignment Getting Started RAID Array 410 for Windows NT Intel SWXSC-AA Components Cabinet removed for clarity Page Host Adapter Installation Intel-based System Install the Host AdapterPreparing to Install the Host Adapter Installing the Host AdapterInstalling the Subsystem Connecting Scsi CableScsi Cable Connection to Controller Single Controller Windows NT Not Installed on System Configuration UtilitiesLoading the Adapter Driver for Use with Windows NT Windows NT Previously Installed Congratulations Verifying the System Recognizes the Host AdapterPage Installing and Using the RAID Manager for Windows NT RAID Manager for Windows NTInstalling the RAID Manager Software Setting Controller CommunicationsSetting the Controller Configuration −2 The System ID WindowClick on OK after making the above selections Creating an Initial Configuration Displaying Physical/Logical View of SystemPhysical View Updated Physical View Practice Example Creating a Single DiskPractice Example Creating a Stripeset Updated Physical View Stripeset Added Practice Example Creating a MirrorsetUpdated Physical View Mirrorset Added Practice Example Adding a Spare DiskCongratulations Practice Example Deleting StoragesetsSaving the RAID Configuration Record the information in the following table Page Completing Configurations under Windows NT Verifying that hszdisk.sys LoadedCompleting a New RAID Array Configuration −2 How The hszdisk Entry Appears When It Fails To LoadUnderstanding the Disk Administrator Display Disk Administrator Screen DisplayCompleting Your Configuration Setup Under Windows NT Getting Started RAID Array 410 for Windows NT Intel Tools Pull-Down Choices Changes to RAID Array Configuration Format MenuCompleting Your Configuration Setup Under Windows NT Configuration Records Blank Forms Getting Started RAID Array 410 for Windows NT Intel Appendix A. Configuration Records Blank Forms Getting Started RAID Array 410 for Windows NT Intel What is the CLI? Accessing the CLISet the communications parameters to Reader’s Comments