Intel 410 manual Figures

Getting Started - RAID Array 410 for Windows NT – Intel

3.7	Saving the RAID Configuration	3–12
4 Completing your Configuration Setup under Windows NT
4.1	Completing Configurations under Windows NT	4–1
4.1.1	Verifying that hszdisk.sys Loaded	4–1
4.1.2	Completing a New RAID Array Configuration	4–2
4.1.3	Changes to RAID Array Configuration	4–7

Appendix A Configuration Records – Blank Forms

Appendix B Accessing the Command Line Interpreter (CLI)

Figures

1–1	Minimum Installation Clearance Measurements	1–1
1–2	Unpacking the RAID Array 410	1–3
1–3	Installation of Ramp on Shipping Pallet	1–3
1–4	PC (Program) Card Slot Location	1–6
1–5	StorageWorks SCSI Bus Port and SCSI ID Assignment	1–7
1–6	SWXSC-AA Components	1–9
2–1	Connecting SCSI Cable	2–3
2–2	SCSI Cable Connection to Controller (Single Controller)	2–4
2–3	SCSI Cable Connection to Controller (Dual Controller)	2–4
3–1	RAID Manager Main Window (Upper Portion)	3–2
3–2	The System ID Window	3–3
3–3	Controller Configuration Window (Upper Portion)	3–4
3–4	Physical View	3–6
3–5	Updated Physical View	3–7
3–6	Create Window	3–7
3–7	Updated Physical View – Disk (JBOD) Added	3–8
3–8	Updated Physical View – Stripeset Added	3–9
3–9	Updated Physical View – Mirrorset Added	3–10
3–10	Delete Window	3–11
4–1	How The hszdisk Entry Appears When It Loads Successfully	4–1
4–2	How the hszdisk Entry Appears When It Fails To Load	4–2
4–3	Disk Administrator Screen Display	4–3
4–4	Partition Pull-Down Menu	4–5
4–5	Create Primary Partition Window	4–5
4–6	Tools Pull-Down Choices	4–6
4–7	Format Menu	4–7

iv EK–SMRAC–IG. B01