Powering On/Off the Projector
Powering On the Projector:
1.Remove the projector lens cap.
2.Complete the AC power cord and peripheral signal cable(s) connections.
3.Press 
button to turn on the projector. The projector takes a minute or so to warm up.
4.Turn on your source (computer, notebook, DVD, etc.). The projector automatically detects your source.
If you are connecting multiple sources to the projector simultaneously, press
the Source button.
Warning:
Remove the lens cap first before powering on.
Never look into the lens when the lamp is on. This can damage your eyes. It is especially important that children are not allowed to look into the lens.
Powering Off the Projector:
1.Press 
button to turn off the projector lamp. You will see a message "Power off? Press Power again" appear on the screen.
2.Press 
button again to confirm.
The cooling fans continue to operate for cooling cycle.
When the Lamp LED begins flashing, the projector has entered
If you want to turn the projector back on, you must wait until the projector has completed the cooling cycle and has entered
by mode, simply press 
button to restart the projector.
3.Disconnect the AC power cord from the electrical outlet and the projector.
4.Do not turn on the projector immediately following a power off procedure.
ViewSonic | 11 | PJ551D |