Eiki EZ 250 owner manual Reset Button

Page 19

5. Enter the RS232 command then select OK

6.Select Upload New Configuration to Control Or

7.The software will prompt you to press the reset button. (reset button is located on the back of the EZ 250)

Reset Button

8.After the programming status disappears disconnect the cables from the computer and press the reset button on the back of the EZ 250 and you are ready for the installation of the EZ 250

Reset Button

- 15 -

Page 18 Page 20
Image 19
Page 18 Page 20
Contents
EZ250 Page Table of Contents Iii EZ 250 Parts List Items Provided by Installer Preloaded Eiki Code Plug and Play SET UPPreloaded Timers Connects to EZlink On the hub EZ 250 LayoutEZ 250 software Installation Programming EZ Programming using a Saved fileStandard Programming Reset Button Standard Programming for 2 Devices Standard Programming for a LSE device and a another Device Advanced Programming Selecting Contact Closure Custom Programming Reset Button Timer Programming Labeling Buttons Page Installation of EZ Installing EZ 250 with ONE Device Installing EZ 250 with TWO Devices Installing EZ 250 with another EZ Two EZ 250s Installing EZ 250 with the option Contact closures Installing a EZ 250 with a NPC-1 Page EZ 250 Operational Troubleshooting EZ 250 Software Troubleshooting
Top Page Image Contents