Programming EZ 250
(Best viewed in 1024 x 768 or higher)
1.To connect your EZ 250 controller to your EZlink Hub interface take two
(2) standard cat5 cables and connect the first cable between EZlink 1 port on the interface and EZ 1 port on the controller and the second cable to the EZlink 2 port of the interface and EZ 2 port of the controller.
2.Take a DB9 female to a DB9 female cable and plug one end into
3.Set the dip switches on the EZlink interface (see page 25)
4.Connect the power supply to the EZlink hub .
5.Then choose which level of programming you will need
In this section the different ways to program the EZ 250 will be explained.
Programming using a Saved file
1.Select EZ 250 under EIKI by clicking on the start menu, then all programs, then EIKI and select EZ 250
2.Select File
3.Then Open
4.Select saved file
- 7 -