ENGLISH
Important:
configuring balanced/
18
Initial Setup
Your new Classé amplifier is quite simple to set up and enjoy. Please follow the steps outlined below in order to safely set up and use your new amplifier.
The AC mains connection should be the last connection you make on your new power amplifier. In addition, it is always a good idea to power up your power amplifier(s) last, after everything else has been powered up and has stabilized. .
Conversely, it is good practice to power the amplifier(s) down first when shutting down the system, as this prevents any transients from other components from getting through to your loudspeakers.
1.Unpack everything according to the included instructions. Be careful when doing so, as this amplifier is quite heavy.
2.Place your amplifier (be sure to read “Unpacking and Placement”) and connect it to the AC mains.
This includes deciding on the location, making sure you have adequate ventilation, and adequate clearance for all the wires behind the amplifier. Once accomplished, connect the amplifier directly to the AC mains. Do not use extension cords, as most are not suitable for the current sometimes required by your amplifier.
3.Configure your amplifier.
The Select and Mode buttons are used when configuring your amplifier for how you would like it to operate.
While in standby, pressing the Select button will cause one of the Channel LEDs to light up, indicating how the amplifier is currently configured (either balanced or
One of the Channel LED indicators will be blinking, indicating that you may select either balanced or
To finish, press and release the Select button until both Channel LEDs are off.
Make sure you configure the amplifier to use the type of input connection you will be using.