2INSTALLATION, Powering ON/OFF the Projector

2INSTALLATION.

2-1 POWERING ON/OFF THE PROJECTOR

2-1-1 POWERING ON THE PROJECTOR

1.Ensure that the supplied power cord is securely connected at the AC inlet of the projector (Drawing 8) and power outlet.

2.Remove the lens cap.

3.Turn on the power switch. Ensure the "Standby/On" button on the Control Panel is flashing green, indicating the projector is in Standby mode.

4.Turn on the Lamp by pressing the "Standby/On" button on the Control Panel or the "Power" button on the Remote Control. Ensure that the "Standby/On" button is continuous green, indicating the projector is on.

DRAWING 8

5.The start-up screen appears on the screen and starts to count down for 30 seconds.

6.The projector will detect the input source automatically.

7. Play your source device

Power switch

AC inlet

2-1-2 POWERING OFF THE PROJECTOR

1.Turn off your source device first.

2.Press the "Standby/On" button on the Control Panel or press the "Power" button on remote control, and a message "If no disk in the DVD slot push again standby button to turn off." will show on the screen.

3.Promptly press the "Standby/On" button or the "Power" button again to confirm turning off the projector. Otherwise the message will disappear after 5 seconds

4.The projector will begin a 90 second cooling down phase.

Note: Please don't turn off the power switch or disconnect the power cord during the cooling down period.

5.When the projector has cooled down, the "Standby/On" button on the Control Panel will be flashing green, indicating the projector is in Standby mode.

6.Turn off the power switch. Replace the lens cap.

7.Disconnect the power cord from the AC inlet of the projector and power outlet.

밐 밐