Eiki EIP-10V owner manual Adjusting the Projector Image, Adjusting the Projector Height

INSTALLATION

2-2 ADJUSTING THE PROJECTOR IMAGE

2-2-1 ADJUSTING THE PROJECTOR HEIGHT

1.Press the Elevator buttons. (Drawing 9 and 10)

2.Raise the projector to the desired display angle, allowing the legs to extend, and then release the buttons to lock them in position.

3.Use the Adjustable foot (Drawing11) at the rear of the unit to fine-tune the display angle.

4. Use the Keystone key on the Remote Control or in the OSD to correct any distortion caused by tilting the projector. (Drawing12)

DRAWING 9

Elevator Button

DRAWING 10

Elevator Button

DRAWING 11

Increase (+) Keystone value

DRAWING 12

Elevator foot

Decrease (-) Keystone value Adjustable foot

2-2-2 ADJUSTING THE PROJECTOR ZOOM/FOCUS

DRAWING 13

Adjust the Zoom ring to adjust image size. Rotate the Focus ring to focus the image. The projector will focus at distances from 1.5m (60in. / 5 ft.) to 10m (394 in. / 32.9 ft.). The optimum distance is from 1.5 m to 5 m (197 in. / 16.5 ft.).

Zoom Ring Focus Ring

밐 뺩