SETTING
Power management
This function turns Projection Lamp off when this projector detects signal interruption and is not used for a certain period in order to reduce power consumption and maintain the
Power Management function operates to turn Projection Lamp off when the input signal is interrupted and any button is not pressed over 5 minutes. This function operates as follows;
1.When any input signal is interrupted, “No signal” and the counting down display appears (for 5 minutes).
2.After counting down for 5 minutes, Projection Lamp and READY Indicator are turned off. (Cooling Fans keep running.)
3.READY Indicator starts to flash after cooling down Projection Lamp about for 90 seconds (Power Management mode).
In this Power Management mode, Projection Lamp is automatically turned on when the input signal is connected or projector is operated with any button on Top Control or on Remote Control Unit again.
Remote control
This projector has two different remote control codes; the
When operating projector in “Code 2,” both projector and Remote Control Unit must be switched to “Code 2.”
To change the code of Projector;
Set Remote control in the SETTING MENU to “Code 2.”
To change the code of the Remote Control Unit;
Press both MENU and IMAGE buttons on Remote Control Unit together for over 10 seconds.
After changing the code, make sure Remote Control Unit operates properly.
To return to the normal code (Code 1), operate both projector and Remote Control Unit in the ways above again.
NOTE : When battery of Remote Control Unit is replaced, the remote control code automatically returns to the normal code (Code 1).
Lamp counter reset
This function is used to reset Lamp Replace Counter. When replacing Projection Lamp, reset Lamp Replace Counter by using this function. Refer to page 38 for operation.
Time left until Lamp off.
36