Maintenance and Cleaning
Lamp Replacement
When the life of the projection lamp of this projector | TOP CONTROL |
draws to an end, the LAMP REPLACE indicator emits |
|
a yellow light. If this indicator lights yellow, replace the |
|
lamp with a new one promptly. |
|
WARNING: |
|
TURN OFF THE UV LAMP BEFORE |
|
OPENING THE LAMP COVER |
|
T h i s i n d i c a t o r i s yellow when the life of the projection lamp draws to an end.
CAUTION | CAUTION |
Allow a projector to cool, for at least 45 minutes before you open the Lamp cover. The inside of the projector can become very hot.
For continued safety, replace with a lamp of the same type. Do not drop a lamp or touch a glass bulb! The glass can shatter and may cause injury.
Follow these steps to replace the lamp.
1 | Turn off the projector and disconnect the AC power |
| cord. Allow the projector to cool for at least 45 |
| minutes. |
2 | Loosen the screw with a screwdriver, and remove |
| the lamp cover. |
3 | Loosen the 3 screws of the lamp with a screwdriver |
| and lift the lamp out of the projector by using the |
| built in handles. |
4 | Replace the lamp with a new one and secure it |
Lamp Cover | Screw |
Screw
| with the 3 screws. Make sure that the lamp is set |
| properly. Replace the lamp cover and tighten the |
| screw. |
5 | Connect the AC power cord to the projector and |
| turn on the projector. |
6 | Reset the lamp replacement counter.. |
| See "Lamp Replacement Counter" on the next |
page .
Lamp
Screw
Screw
Handles
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer.
● Model No. of your projector | : |
● Replacement Lamp Type No. | : |
| (Service Parts No. 610 330 4564) |
54