Eiki LC-XB21A owner manual Remote Control Battery Installation, Operating Range

Page 12

Part Names and Functions

Remote Control Battery Installation

1

Open the battery

 

compartment lid.

2

Install new batteries

 

into the compartment.

Two AA size batteries

For correct polarity

(+ and –), be sure battery terminals are in contact with pins in the compartment.

3

Replace the

 

compartment lid.

To ensure safe operation, please observe the following precautions:

Use two (2) AA or LR6 type alkaline batteries.

Always replace batteries in sets.

Do not use a new battery with a used battery.

Avoid contact with water or liquid.

Do not expose the remote control to moisture or heat.

Do not drop the remote control.

If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.

Risk of explosion if a battery is replaced by an incorrect type.

Dispose of used batteries according to the instructions.

Operating Range

Point the remote control toward the projector (Infrared Remote Receiver) when pressing any button. Maximum operating range for the remote control is about 16.4' (5 m) and 60° in front of the projector.

16.4' (5 m)

Remote control

60°

LC-XB21A

Avanti

12

Image 12
Contents Model LC-XB21A Features and Design Table of Contents To the Owner Risk of Electric Shock Do not OpenSafety Instructions Installing the Projector in Proper Position Air CirculationMoving the Projector Compliance Federal Communications Commission NoticePart Names and Functions FrontBack BottomRear Terminal ② Computer in /S-VIDEO in /COMPONENTTop Control Remote Control Remote Control Battery Installation Operating RangeInstallation Adjustable FootPositioning the Projector NoteConnecting the AC Power Cord Projector side AC outlet sideConnecting to a Computer Cables used for connectionConnecting to Video Equipment Connecting to Component Video Equipment Selected Input Source and Lamp Mode Basic OperationTurning On the Projector PIN Code Input Dialog BoxTurning Off the Projector How to Operate the On-Screen Menu Remote ControlTop Control On-Screen MenuMenu Bar Zoom and Focus Adjustment Keystone CorrectionSound Adjustment Remote Control OperationTimer button Auto PC buttonZoom buttons No Show buttonComputer Input Input Source SelectionDirect Operation Source Select MenuComputer System Selection Selecting Computer System ManuallyPC System Menu Auto PC Adjustment To store adjustment parametersPC Adjust Menu Menu Operation Auto PC AdjManual PC Adjustment Reset Mode freeTo clear adjusted data To store adjusted dataImage Level Selection Image Level Adjustment Screen Size Adjustment NormalTrue WideFor zooming in and out the images Digital zoom +Digital zoom Video Input Input Source Selection VideoInput Source Selection S-Video, Component, RGB Scart 21-pin Direct Operation Top ControlVideo System Selection AutoAV System Menu Video or S-Video AV System Menu ComponentCinema Image 1~4Color TintNoise reduction ProgressiveProvide the image at a normal video aspect ratio Setting SettingSetting Logo PIN code lock To Enter the Logo PIN code Setting Power management Power consumption and extends Security Key lock and PIN code lock settings Key lockPIN code lock Change the PIN code lock setting Change the PIN codeFactory default FanLamp counter Maintenance and Cleaning Note Then check the matters belowCleaning the Air Filters Attaching the Lens CoverCleaning the Projection Lens Cleaning the Projector CabinetLamp Replacement Reset the lamp replacement counterLamp Handling Precautions Lamp Replacement CounterTroubleshooting AppendixAppendix Image Adjust Menu TreeAppendix Video Input Indicators and Projector Condition IndicatorsCompatible Computer Specifications FreqTechnical Specifications Mechanical InformationOptional Parts COMPONENT-VGA CableSCART-VGA Cable VIDEO-VGA CableConfigurations of Terminals DimensionsTerminal Analog RGB Mini D-sub 15 pin Terminal Mini DIN 8-PINLogo PIN Code Lock No PIN Code Number MemoDeutschland & Österreich ChinaCanada Eastern Europe