Eiki LC-XB23 owner manual On start, Lamp control, To change the code for the projector

Setting

On start

When this function is “On”, the projector will be automatically turned on just by connecting the AC power cord to a wall outlet.

✔Note:

Be sure to turn the projector off properly (see “Turning Off the Projector” on page 19). If the projector is turned off in the incorrect sequence, the On start function does not operate properly.

Setting

Lamp control

This function allows you to change brightness of the screen.

Normal ....normal brightness

Auto ........brightness according with the input signal

Eco ..........lower brightness reduces the lamp

power consumption and extends the lamp life.

Remote control

This projector provides two different remote control codes; the factory-set, initial code (Code 1) and the secondary code (Code 2). This switching function prevents remote control interference when operating several projectors or video equipment at the same time.

When operating the projector in “Code 2”, both the projector and the remote control must be switched to “Code 2”.

To change the code for the projector;

Select either “Code 1” or “Code 2” in this Setting Menu.

To change the code for the remote control;

Press and hold both the MENU and IMAGE buttons together for 10 seconds or more. After changing the code, make sure the remote control operates properly.

Remote control

Press and hold MENU and IMAGE buttons for 10 seconds or more.

45