Eiki LC-SX3L instruction manual PC Adjustment

COMPUTER MODE

PC ADJUSTMENT

This Projector can automatically tune to the display signals from most personal computers currently distributed. However, some computers employ special signal formats which are different from the standard ones and may not be tuned by the Multi-Scan system of this projector. If this happens, the projector cannot reproduce a proper image and the image may be recognized as a flickering picture, a non-synchronized picture, a non-centered picture or a skewed picture.

This projector has a PC ADJUSTMENT function to enable you to precisely adjust several parameters to match with those special signal formats. This projector has 8 independent memory areas to memorize those parameters manually adjusted. This enables you to recall the setting for a specific computer whenever you use it.

Note : This PC ADJUSTMENT function will be skipped when the incoming signal is digital.

1	Press the MENU button and the ON-SCREEN MENU will
	appear. Press the POINT RIGHT/LEFT button to select PC
	ADJUST and press the SELECT (REAR CLICK) button. Another
	dialog box “Where to reserve” Menu will appear.
2	In this dialog box, you can store the parameter into the area from
	“Mode 1” to “Mode 8.” When memorizing the new computer
	parameter, select the Mode with the message “Free” by pressing
	the POINT UP/DOWN button and the SELECT (REAR CLICK)
	button. To change the parameters of the Mode previously set,
	select the Mode with “Stored.”
3	When the Mode is selected, Parameter adjustment dialog box
	appears. Move the arrow to the item that you want to change by
	pressing the POINT UP/DOWN button, and adjust each item by
	pressing the SELECT (REAR CLICK) button to match with your
	computer.
4	Move the arrow to “Stored” and press the SELECT (REAR
	CLICK) button. The parameter is memorized in the selected
	Mode.
5
	To activate the Mode manually adjusted in this PC
	ADJUSTMENT Menu, select the Mode at the SYSTEM SELECT

Menu. (Refer to page 36.)

This Mode has parameters being stored.

The Vacant Mode.

Manual set Computer

Mode (1 to 8).

Close the PC ADJUSTMENT Menu.

Move the arrow to ▲ or

▼and press SELECT (REAR CLICK) button.

38