Setting Menu

SETTING

1		Press the MENU button and the ON-SCREEN MENU will
1		appear. Press the POINT LEFT/RIGHT buttons to select
		SETTING and press the SELECT (REAR CLICK) button.
		SETTING and press the SELECT (REAR CLICK) button.
		Another dialog box SETTING Menu will appear.
2
		Press the POINT DOWN button and a red-arrow icon will
		appear. Move the arrow to the item that you want to set, and

then press the SELECT (REAR CLICK) button to set it "On" or "Off" or press the POINT LEFT/RIGHT button to adjust the value.

Blue back

When this function is “On,” this projector will produce a blue image instead of the video noise on the screen when the input source is unplugged or turned off.

Display

This function decides whether to display the On-Screen Displays.

On ···shows all the On-Screen Displays.

Off ····sets the On-Screen Displays disappeared except;

●ON SCREEN MENU

●“Power off?” message

●P-TIMER

Reverse T/B

When this function is “On,” the top / bottom reversed picture is provided to project the image from a ceiling mounted projector.

Reverse L/R

When this function is “On,” the left / right reversed picture is provided to project the image to a rear projection screen.

Split wipe

Turn this function “On” in the SETTING menu. The picture will change into next one by sliding black image side ways like drawing the black curtains when the input source is turned into another one.

Power management

This function turns the Projection Lamp off when the projector detects signal interruption and the projector is not used for a certain period in order to reduce power consumption and maintain the Lamp- life. (This projector is shipped with this function ON.)

Power Management function operates to turn the Projection Lamp off when the input signal is interrupted and the projector is not operated over 5 minutes. This function operates as follows;

1.When the signal is interrupted, “No signal” and the counting down (5 minutes) display appears.

2.When the Projection Lamp turned off, the READY indicator turns off. The Cooling Fans operate for 90 seconds after the Projection Lamp is turned off. (During this "Cooling Down" period, the Lamp cannot be turned on.)

3.When the Lamp has cooled down, the READY indicator flashes and the Lamp can be turned on again (Power Management mode).

In this Power Management mode, the Projection Lamp is automatically turned on when the input signal connected or the projector is operated with any button on the Top Control or on the Remote Control.

Set the Pointer to the item and press the SELECT (REAR CLICK) button.

Reverse T/B function

Reverse L/R function

Time left until Lamp off.