Konica Minolta C650 manual Selecting Finishing settings

Using copy functions 2

2.7Selecting Finishing settings

Various settings can be selected for sorting and finishing copies fed into the output tray.

The following Finishing settings are available.

Setting	Description
Collate (By Set)	Select this setting to separate each set of a multi-page
	document.
Group	Select this setting to separate the copies of each page in a multi-
	page document.
Offset*1	Select this setting to feed out and sort printed copies in an
	alternating crisscross pattern if the sorting conditions are met
	when no finisher is installed.
	Select this setting to feed out and stack the printed copies on top
	of each other with each set shifted to separate it when a finisher
	is installed.
Staple*2*3	Select one of these settings to bind the printed copies with
	staples. “Corner” or “2 Position” can be selected.
Punch*4*5	Select one of these settings to punch holes in the copies for filing
	them.
Half-Fold*6	Select this setting to fold copies in half before feeding them out.
Center Staple & Fold*6	Select this setting to staple copies at two places along the
	center, then fold the copies in half before feeding them out.
Tri-Fold*6	Select this setting to fold copies in three before feeding them out.

*1 If no finisher is installed and all of the following conditions are met, printed copies can be fed out and sorted in an alternating crisscross pattern.

–8-1/2 × 11 or 5-1/2 × 8-1/2-size (A4- or B5-size) paper is used.

–Paper of the same size and type is loaded with the w orientation in one paper tray and with the v orientation in another tray.

–The “Auto” Paper setting is selected.

–The “Auto” Paper setting is not selected when the “Mixed Original” setting is selected.

*2 If a Staple setting is selected, the “Collate (By Set)” setting is automatically selected. The “Offset” setting cannot be selected at the same time that a Staple setting is selected.

*3 The Staple settings are available only if the optional finisher is installed.

*4 The Punch settings are available only if punch kit is installed on optional finisher.

Using copy functions Chapter 2

C650 2-17