Intel TPC-1070 user manual Panel Mounting

Page 19

1.7 Panel Mounting

1.There is a piece of adhesive waterproof gasket on the Mg-AL front bezel. Make sure the waterproof gasket is in position before installing the TPC-1070 to the panel opening.

2.Install the TPC-1070 to the panel opening.

3.Find out the eight clampers and eight long screws in the accessory pack. Hook those clampers to those holes around the four sides of the bezel. Insert the screws to every clamper and fasten them. These screws will then push on the mounting panel and fix the unit.

4.The mounting panel thickness is suggested to be less than 10mm (0.236 inch).

Figure 1.2: Panel Mounting

7

Chapter1

Image 19

Contents TPC-1070 Copyright Acknowledgements Product Warranty 2 years FCC Class a Technical Support and Assistance Declaration of ConformitySafety Instructions Wichtige Sicherheishinweise Vii Viii Contents Appendix Serial Port Settings Appendix G Xii General Information Introduction SpecificationsEnvironment SafetyRJ-45 Ethernet port Compact Flash Slot TypeII PCI-104LCD Specifications Power Touchscreen SpecificationsI/O port arrangement I/O Port ArrangementPanel Mounting Panel MountingDimensions Dimensions & CutoutSystem Setup Install CompactFlash memory card Power receptor and button pin assignments Touchscreen Calibration System Engine Main Board Connector Main Board Connector and Jumper Setting ListSoftware Configuration Path \TPC-1070H\Driver\VGA\ Available for the OS’s below Utilities & DriversPath \TPC-1070H\Driver\LAN\ Available for the OS’s below Advantech COM Driver Advantech COM Driver Installation Click Next to continue installation Click uninstall icon to remove ?PCI Serial Port Page Found New Hardware and Click Next to continue installation Click Finish the Advantech PCI Serial Port to continue Page Found New Hardware and Click Next to continue installation Watchdog Timer WDT Driver Installation Installing the TPC-1070 Watchdog Timer Driver Click Next to proceed Page Page Page How to Use the TPC-1070 Watchdog Timer Page Page Windows XP Embedded Horm EWFVersion Information Advantech UtilitiesOSLock and OSUnLock Serial Port Settings COM1/ COM3 Connector Definition Appendix a Serial Port SettingsCOM4 Setting RS422-MASTER Page Watchdog Timer on WinCE DeviceIOControl Appendix B Watchdog Timer on WinCEAppendixB Ioctl Wdtenable How to Use the Control CodeIoctlwdtgettimeout Examples CTLCODEFILEDEVICEUNKNOWN,ID, METHODBUFFERED, FileanyaccessAppendixB Page Watchdog Timer Programming Overview Appendix C Watchdog Timer ProgrammingFigure C.1 Watchdog timer programming procedure Watchdog Timer ProgrammingTable C.1 Watchdog Timer Registers Example Programs Enable watchdog timer and set 10 sec. as timeout intervalEnable watchdog timer and set 5 minutes as timeout interval Enable watchdog timer to be reset by mouse Enable watchdog timer to be reset by keyboard Generate a time-out signal without timer counting Page Accessory Kit Assembly CompactFlash to IDE Transfer Kit Appendix D Accessory Kit AssemblyFigure D.3 CompactFlash Slot Figure D.6 Connect the CD-ROM via the IDE Cable USB Driver Installation NoticeHDD Kit Assembly Figure E.1 Removing the Rear HDD Cover Appendix E HDD Kit AssemblyTouchscreen Installation Configuration Driver Installation Appendix F Touchscreen Installation & ConfigurationFigure F.3 Install License Agreement Figure F.5 Uninstall Uninstall the DriverCalibrate Touchscreen CalibrationFigure F.8 Standard Calibration Figure F.10 Standard Calibration Figure F.11 Advanced Calibration Draw Figure F.13 Plot Calibration DataFigure F.14 Draw Figure F.16 Option OptionPage Fuse Specifications Fuse Specifications Appendix G Fuse SpecificationsFuse Replacement