Intel TPC-1070 user manual Ewf, Horm

Page 48

Chapter 5 Windows XP Embedded

TPC-1070 is in support of embedded windows platform. This section is to state the important features, EWF and HORN, provided in windows XP embedded.

5.1 EWF

EWF stands for Enhanced Write Filter. It provides an upper filter in the storage device driver stack that redirects disk write operations to volatile (RAM) or non-volatile (disk) storage. EWF protects a volume from write access. The benefits are as the following.

Write-protect one or more partitions on your system.

Enable read-only media, such as CD-ROM or flash, to boot and run. Prolong the lifespan of write-sensitive storage, such as CompactFlash.

TPC-1070 XPE provides EWF RAM RDG mode on system partition. All wirte to system partition will be redirected to RMA once this mode is enabled. This mode is manually enabled by customers after they finish all their changes on system such as installing their applications or adjust- ing system setting.

Advantech provides a pair of utilities to operate EWF, OSLock and OSUnLock. The setting is stated in the section later.

5.2 HORM

HORM stands for Hibernate Once Resume Many. In HORM environ- ment, a single hibernation file is used to boot the system repeatedly. To set a HORM environment, please follow the steps below.

Please make sure EWF is disabled. You can run OSUnLock to disable EWF.

Enable hibernation support:

Run ‘power options’ in control panel, and then select ‘Enable Hiberna- tion’ in hibernation pane.

TPC-1070 User Manual

36

Image 48
Contents TPC-1070 Copyright Acknowledgements Product Warranty 2 years Declaration of Conformity FCC Class a Technical Support and AssistanceSafety Instructions Wichtige Sicherheishinweise Vii Viii Contents Appendix Serial Port Settings Appendix G Xii General Information Specifications IntroductionSafety RJ-45 Ethernet portCompact Flash Slot TypeII PCI-104 EnvironmentLCD Specifications Touchscreen Specifications PowerI/O Port Arrangement I/O port arrangementPanel Mounting Panel MountingDimensions & Cutout DimensionsSystem Setup Install CompactFlash memory card Power receptor and button pin assignments Touchscreen Calibration System Engine Main Board Connector and Jumper Setting List Main Board ConnectorSoftware Configuration Utilities & Drivers Path \TPC-1070H\Driver\VGA\ Available for the OS’s belowPath \TPC-1070H\Driver\LAN\ Available for the OS’s below Advantech COM Driver Advantech COM Driver Installation Click Next to continue installation Click uninstall icon to remove ?PCI Serial Port Page Found New Hardware and Click Next to continue installation Click Finish the Advantech PCI Serial Port to continue Page Found New Hardware and Click Next to continue installation Watchdog Timer WDT Driver Installation Installing the TPC-1070 Watchdog Timer Driver Click Next to proceed Page Page Page How to Use the TPC-1070 Watchdog Timer Page Page Windows XP Embedded EWF HormAdvantech Utilities Version InformationOSLock and OSUnLock Serial Port Settings Appendix a Serial Port Settings COM1/ COM3 Connector DefinitionCOM4 Setting RS422-MASTER Page Watchdog Timer on WinCE Appendix B Watchdog Timer on WinCE DeviceIOControlAppendixB How to Use the Control Code Ioctl WdtenableIoctlwdtgettimeout CTLCODEFILEDEVICEUNKNOWN,ID, METHODBUFFERED, Fileanyaccess ExamplesAppendixB Page Watchdog Timer Programming Appendix C Watchdog Timer Programming OverviewWatchdog Timer Programming Figure C.1 Watchdog timer programming procedureTable C.1 Watchdog Timer Registers Enable watchdog timer and set 10 sec. as timeout interval Example ProgramsEnable watchdog timer and set 5 minutes as timeout interval Enable watchdog timer to be reset by mouse Enable watchdog timer to be reset by keyboard Generate a time-out signal without timer counting Page Accessory Kit Assembly Appendix D Accessory Kit Assembly CompactFlash to IDE Transfer KitFigure D.3 CompactFlash Slot USB Driver Installation Notice Figure D.6 Connect the CD-ROM via the IDE CableHDD Kit Assembly Appendix E HDD Kit Assembly Figure E.1 Removing the Rear HDD CoverTouchscreen Installation Configuration Appendix F Touchscreen Installation & Configuration Driver InstallationFigure F.3 Install License Agreement Uninstall the Driver Figure F.5 UninstallTouchscreen Calibration CalibrateFigure F.8 Standard Calibration Figure F.10 Standard Calibration Figure F.11 Advanced Calibration Figure F.13 Plot Calibration Data DrawFigure F.14 Draw Option Figure F.16 OptionPage Fuse Specifications Appendix G Fuse Specifications Fuse SpecificationsFuse Replacement