INSTALLATIONS
Reset Switch: Pins 9 and 19
The reset switch allows the user to reset the system without turning the main power switch off and then on again. Orientation is not required when making a connection to this header.
Hard Disk Drive LED Connector: Pins 10 and 20 This connector connects to the hard drive activity LED on control panel. This LED will flash when the HDD is being accessed.
| Pin # | Signal Name |
| 10 | HDD Active |
| 20 | 5V |
J11: IrDA Connector |
|
|
Pin # | Signal Name | |
1 | +5V |
|
2 | No connect | |
3 | Ir RX |
|
4 | Ground |
|
5 | Ir TX |
|
22 | MB898 User’s Manual |