Intel E7501 ATX Power Installation, Installing the Memory, Supported DDR Dimm Configurations

INSTALLATIONS

ATX Power Installation

The system power is provided to the AFW-3000 Server Motherboard with the CN7 and CN8 ATX power connectors. CN8 is a 4-pin power connector. CN7 is a 20-pin ATX power connector.

Installing the Memory

The AFW-3000 Server Motherboard supports two DDR memory sockets for a maximum total memory of 4GB in DDR memory type.

Note: DIMM modules must be DDR/ECC/Reg Only. Modules “in pairs” must be the same type and size.

The memory module capacities supported are 64MB, 128MB, 256MB, 512MB, 1GB and 2GB. The following table lists the supported DDR DIMM configurations.

Supported DDR DIMM Configurations.

Density	64 Mbit		128Mbit		256Mbit		512Mbit
Device	X4	X8	X4	X8	X4	X8	X4	X8
Width
Single/	SS/DS	SS/DS	SS/DS	SS/DS	SS/DS	SS/DS	SS/DS	SS/DS
Double
184-pin	128/256MB	64/128MB	256/512MB	128/256MB	512MB	256/512MB	1GB/2GB	512MB
DDR					/1GB			/1GB

Installing and Removing Memory Modules

To install the DDR modules, locate the memory slot on the Server Motherboard and perform the following steps:

1.Hold the DDR module so that the keys of the DDR module align with those on the memory slot.

2.Gently push the DDR module in an upright position until the clips of the slot close to hold the DDR module in place when the DDR module touches the bottom of the slot.

AFW-3000 User’s Manual 9