Intel E7501 Wake Up by PCI Card, Power On by Ring, Resume by Alarm, Reload Global Timer Events

Page 42

BIOS SETUP

Wake Up by PCI Card

This field allows the system to wake up from a signal received from a PCI card such as a LAN card.

Power On by Ring

This field enables or disables the power on of the system through the modem connected to the serial port or LAN.

Resume by Alarm

This field enables or disables the resumption of the system operation. When enabled, the user is allowed to set the Date and Time.

Reload Global Timer Events

The HDD, FDD, COM, LPT Ports, and PCI PIRQ are I/O events which can prevent the system from entering a power saving mode or can awaken the system from such a mode. When an I/O device wants to gain the attention of the operating system, it signals this by causing an IRQ to occur. When the operating system is ready to respond to the request, it interrupts itself and performs the service.

38

AFW-3000 User’s Manual

Image 42
Contents USER’S Manual VersionAcknowledgments Table of Contents This page is intentionally left blank Introduction Product DescriptionChecklist Specifications ChipsetQuick Guide KB/MS LPT VgaconnBoard Dimensions This page is intentionally left blank Installations Installing the CPU ATX Power Installation Installing the MemorySupported DDR Dimm Configurations To remove the DDR module, press the clips with both hands Setting the Jumpers Jumper Locations on AFW-3000 SW1 1-4 For 82546EB Gigabit LAN-1 CN1, CN2 SW1 5-8 For J2 PCI/PCI-X SlotConfiguring the CPU Frequency JP6 Clear Cmos ContentsSW2 1-4 For 82546EB Gigabit LAN-2 CN11, CN12 JP8 Power Reset Switch JP9 AT / ATX Power Supply SelectJP1, JP2, JP3, JP5 Reserved Jumpers Connectors on AFW-3000 Connector Locations on AFW-3000 CN1, CN2, CN3, CN4 Gigabit LAN RJ45 Connectors CN6 CF Card Connector Type CN7 ATX Power Supply ConnectorCN5, J9 Serial Ports J6 External Keyboard Connector CN8 ATX 12V/+12V Power ConnectorJ1 VGA CRT Connector UJ1, UJ2 USB PortsPin RJ45 LED Signal J7 Extra Lanled DefineJ8 Parallel Port Connector IDE1 Eide ConnectorInstallations FDD1 Floppy Drive Connector FAN1, FAN2, FAN3, FAN4 CPU Fan Power ConnectorsBios Setup Bios Introduction Bios SetupPhoenix Award WorkstationBIOS Cmos Setup Utility Standard Cmos Setup DateTime IDE Primary HDDs / IDE Secondary HDDsDrive a / Drive B Video Halt OnCPU Internal Cache / External Cache Advanced Bios FeaturesVirus Warning Hyper-Threading TechnologyBoot Other Device Quick Power On Self TestFirst/Second/Third Boot Device Boot Up Floppy SeekSecurity Option Typematic Delay MsecVideo Bios Shadow MPS Version Control for OSAdvanced Chipset Features Integrated Peripherals OnChip IDE DeviceOnboard Device Super IO Device Power Management Setup Power ManagementAcpi Function Video Off Method Suspend ModeHDD Power Down Video Off In SuspendReload Global Timer Events Power On by RingResume by Alarm Wake Up by PCI CardResources Controlled by PNP/PCI ConfigurationsPNP OS Installed IRQ / DMA ResourcesPC Health Status CPU Warning TemperatureTemperatures/Fan Speeds/Voltages Fan Failure WarningAuto Detect DIMM/PCI Clk Frequency/Voltage ControlCPU Clock Ratio Spread SpectrumSet Supervisor/User Password Load Fail-Safe DefaultsLoad Setup Defaults Save & Exit SetupThis page is intentionally left blank Drivers Installation Intel E7501 Chipset Drivers Installation VGA Driver Installation Ethernet Drivers