Intel 915GM user manual Display

Page 7

Product Overview

Display:

yAnalog CRT DAC interface support

-24-bit RAMDAC support (8-bit for each RGB signal DAC)

-Resolution up to 2048 x 1536 at 75Hz

-DDC2B compliant

yAnalog TV-Out interface support

-On board S-Video 4-pin mini DIN connector

yDedicated Local Flat Panel(LFP) LVDS interface

-Compliant with ANSI/TIA/EIA-644-2001 spec

-Supports 25 to 112 MHz single/dual channel LVDS interface with Spread Spectrum Clocking (SSC)

-Support TFT panel type with maximum pixel format of 1x18 bpp for single channel and 2x18 bpp for dual channels

-Maximum Panel size supported up to UXGA

-Maximum Wide Panel size supported up to WUXGA

ySDVO support through Extension Slot

-Two SDVO ports are supported

-Supports a variety display devices such as DVI, TV Out, LVDS, etc

yDual display support

-Independent: different images and native display timings on each display device

-Simultaneous: same images and native display timings on each display device

yDynamic Video Memory Technology (DVMT) 3.0 to dynamically allocate up to 128 MB of system memory for graphics usage

I/O:

yStorage :

-Integrated IDE controller support PIO IDE and Ultra ATA 100/66/33

-One SATA ports support data transfer rate up to 1.5Gb/s (150 MB/s)

-Support Advanced Host Controller Interface (AHCI)

-Type I/II CompactFlash* slot x 1

yKeyboard

yPS/2 Mouse

yAudio :

-Realtek ALC202A AC’97 codec audio

-Amplifier for speaker-out with 2.5 W for each channel

-MIC-in, Line-in, Line-out/Speaker-out (jumper selectable)

yUSB :

-USB 2.0 ports x2

-USB 2.0 on pins header x2

Image 7
Contents June Contents Contents Revision History Related Documents IntroductionRelated Documents Proof-of-Concept Board Features Product ContentsDisplay Block Diagram Before You Begin Setting up the Intel ECX POC BoardAdditional Hardware Jumper Function Default Setting Jumper SettingsAssembly board, Top View Pin Power Supply Connector Installation Guide for POC Board Connectors and Jumpers Jumpers List of JumpersCOM2 Mode Select JP5 Compact Flash Power Select JP1COM1 Mode Select for RS-232/422/485 JP3/JP6/JP7 COM1 Mode Select JP4Front Panel Bezel Connector CN2 List of ConnectorsConnectors Label Function Digital I/O Connector CN1Parallel Port Connector CN4 Primary IDE Hard Drive Connector CN3Lvds Voltage Connector CN8 USB Port2 & Port3 Connector CN5Lvds Connector CN6 Power Connector CN7USB Port0 & Port1 Connector CN12 Serial Port2 Connector CN9LAN Connector CN10 Audio Connector CN11Sata Connector CN17 TV-OUT Connector CN14Serial Port1 Connector CN15 VGA Connector CN16Compact Flash Connector CN19 FDD Connector CN18Fan Connector FAN1