Jumper Settings, Jumper Function Default Setting

Installation Guide for POC Board

2.Verify contents. Inspect the contents of your kit, and ensure that everything listed in Section 1.3 is included. Check for damage that may have occurred during shipment.

3.Check jumper settings. Verify that the following jumpers are set in their default state (see Table 3).

Table 3. Jumper Settings

Jumper	Function		Default Setting
J1	Compact Flash Power Select		3.3 V : Short 1-2
J2	LVDS Voltage select		3.3 V : Short 1-2
J3	COM1 Mode Select		RS-232	: Short 3-5,4-6
J4	COM1 Mode Select	CN15 Pin 1	DCD : Short 3-5

		CN15 Pin 8	RI : Short 4-6


J5	COM2 Mode Select	CN15 Pin 1	DCD : Short 3-5

		CN15 Pin 8	RI : Short 4-6

J6	COM1 Mode Select		RS-232	: Short 3-5,4-6
J7	COM1 Mode Select		RS-232	: Short 1-2

J8	Clear CMOS Setting		Normal : Short 1-2
J9	Audio Line Out/Speaker Out		Line Out : Short 1-3, 2-4

4.Verify installed hardware. Make sure the following hardware is populated on your POC board:

−One on-board Intel Intel® Celeron® M Processor Ultra Low Voltage 373 processor in the 479-ball µFCBGA package

−BIOS FWH

−Battery

−Heatsink

Note: The above hardware should have been correctly installed at the factory. If they are not installed correctly, DO NOT power on the board. Correctly re-install the components before proceeding.

5.Install memory. Install the SODIMM in memory slot DIMM1. Insert the SODIMM above the slot (the DIMM is keyed so that it only fits in the slot in one orientation). Firmly, but carefully, insert the SODIMM into the slot until the tabs close.