Intel 8S661FXM-RZ user manual Install memory modules, Ddr

Page 11

Step 2: Install memory modules

Before installing the memory modules, adhere to the following warning:

Please note that the DIMM module can only fit in one direction due to the one notch. Wrong orientation will cause improper installation. Please change the insert orientation.

The motherboard has 2 dual inline memory module (DIMM) sockets. The BIOS will automatically detects memory type and size. To install the memory module, just push it vertically into the DIMM socket. The DIMM module can only fit in one direction due to the notch. Memory size can vary between sockets.

 

 

Notch

 

 

DDR

Support Unbuffered DDR DIMM Sizes type:

 

64 Mbit (2Mx8x4 banks)

64 Mbit (1Mx16x4 banks)

128 Mbit(4Mx8x4 banks)

128 Mbit(2Mx16x4 banks)

256 Mbit(8Mx8x4 banks)

256 Mbit(4Mx16x4 banks)

512 Mbit(16Mx8x4 banks)

512 Mbit(8Mx16x4 banks)

 

1. The DIMM socket has a notch, so the DIMM memory module can only fit in one direction.

2. Insert the DIMM memory module vertically into the DIMM socket. Then push it down.

3. Close the plastic clip at both edges of the DIMM sockets to lock the DIMM module.

Reverse the installation steps when you wish to remove the DIMM module.

English

- 11 -

Hardware Installation Process

Image 11
Contents 8S661FXM-RZ Motherboard 8S661FXM-RZ Preparing Your Computer Installing the motherboard to the chassisTable of Content Introduction Features SummaryEnglish 8S661FXM-RZ 8S661FXM-RZ Motherboard LayoutBlock Diagram Step Hardware Installation ProcessCPU Installation DDR Install memory modulesInstall I/O Peripherals Cables Install expansion cardsCdin ATX12VFDD IDE1 / IDE2 BATCpufan CPU FAN Connector ATX12V +12V Power ConnectorATX ATX Power IDE1/ IDE2IDE1/IDE2 Connector Sysfan System FAN ConnectorFDD Floppy Connector Fpanel 2x10 pins connector Faudio Faudio Connector BAT BatterySpdifio Spdif In/Out Clrcmos Clear Cmos USB1 / FUSB2 Front USB ConnectorComb COM B Connector CI Chassis Intrusion, Case Open Main Menu Main Menu For example Bios Ver. F8cEntering Bios Setup Status Page Setup Menu / Option Page Setup MenuLoad Fail-Safe Defaults Advanced Bios FeaturesPower Management Setup PnP/PCI ConfigurationIDE Primary Master, Slave / IDE Secondary Master, Slave Standard Cmos FeaturesDate TimeMemory Floppy 3 Mode Support for Japan AreaDrive a / Drive B Halt onBoot Up Floppy Seek Advanced Bios FeaturesFirst / Second / Third Boot Device Init Display First Password CheckCPU Hyper-Threading Integrated Peripherals USB Controller Parallel Port ModeECP Mode Use DMA Onboard LAN devicePower Management Setup System after AC Back Power On by KeyboardPower On by Mouse Resume by AlarmPCI 3 IRQ Assignment PnP/PCI ConfigurationsPCI 1 IRQ Assignment PCI 2 IRQ AssignmentPC Health Status MB Intelligent Tweaker M.I.T Top Performance Set Supervisor/User Password Load Fail-Safe DefaultsLoad Optimized Defaults Exit Without Saving Save & Exit SetupPictures below are shown in Windows XP Install DriversItem Description English Contact US