English
CPU Clock (MHz)
100~355 Select CPU Clock to 100MHz~355MHz.
If you use FSB400 Pentium 4 processor, please set "CPU Clock" to 100MHz.If you use FSB533 Pentium 4 processor, please set "CPU Clock" to 133MHz. If you use FSB800 Pentium 4 processor, please set "CPU Clock" to 200MHz.
Incorrect using it may cause your system broken. For power
DRAM Clock (MHz)
Please set DRAM Clock according to your requirement.
If you use DDR200 DRAM module, please set "DRAM Clock(MHz)" to 200. If you use DDR333 DRAM module, please set "DRAM Clock(MHz)" to 333.
Incorrect using it may cause your system broken. For power
AGP/PCI Clock Control
AUTO | Set AGP/PCI clock automatically. (Default Value) |
Manual | Set AGP/PCI clock manually. |
MIncorrect using it may cause your system broken. For power
AGP Clock (MHz)
Please set AGP Clock according to your requirement.
Incorrect using it may cause your system broken. For power
PCI Clock (MHz)
Please set PCI Clock according to your requirement.
Incorrect using it may cause your system broken. For power
Top Performance
CMOS Setup
} |
|
|
|
|
|
|
|
Standard CMOS Features |
|
| Top Performance |
|
| ||
} | Advanced BIOS Features |
|
| Load | |||
|
| ||||||
} | Integrated PeripheralsTop Performance |
|
| Load Optimized Defaults | |||
} | Power Management Setup |
|
| Set Supervisor Password | |||
} |
| Disabled.........................[n] | |||||
PnP/PCI Configurations |
|
| Set User Password | ||||
} |
| Enabled..........................[ ] | |||||
PC Health Status |
|
|
| Save & Exit Setup | |||
} | Frequency/Voltage Control |
|
| Exit Without Saving | |||
|
|
|
| higf: Select Item |
| ||
ESC: Quit | hi: Move |
|
|
| |||
|
| ENTER: Accept | |||||
F8: | ESC: Abort |
|
| F10: Save & Exit Setup | |||
|
|
|
|
|
|
| |
|
| Time, Date, Hard Disk Type... | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
If you wish to maximize the performance of your system, enable "Top Performance."
Disabled | Disable this function. (Default Value) |
Enabled | Enable Top Performance function. |
"Top Performance" will increase H/W working speed. Different system configuration (both H/W component and OS) will effect the result. For example, the same H/W configuration might not run properly with Windows XP, but works smoothly with Windows NT. Therefore, if your system is not perform enough, the reliability or stability problem will appear sometimes, and we will recommend you disabling the option to avoid the problem as mentioned above.
- 34 - |