MicroBoards Technology manual Attachment C Orbit II Error Messages

	Orbit II Disc-to-Disc Copier Reference Manual – Revision I
	Attachment C Orbit II Error Messages
Error Message:	Problem Description:
!! Bad Copy!!	The copy CD is bad and will be rejected. This message may briefly appear during any of Orbit II’s operating modes.
!!ERROR!! No CD Reader!	This message would appear during a power on self-test if the copy controller did not locate a compatible CD Reader.
	Contact Microboards Technology Technical Support.
!!ERROR!! No CD-R Drives!	This message would appear during a power on self-test if the copy controller did not locate a compatible CD-R/CD-RW
	Writer. Contact Microboards Technology Technical Support.
!!ERROR!! Disc is Blank!	This message would appear at the start of a copy or compare job if the copy controller could not read the disc that is in the
	CD Reader. Check your master CD, CD-R, or CD-RW discs, and try again. If this message persists, contact Microboards
	Technology Technical Support.
Setup Error	The user Setup file has been corrupted. Turn the external power supply OFF, and leave it OFF for a few moments. When
	you turn your Orbit II System back ON it will reset the user Setup file to the factory default values of Burn CD? Yes and
	48x Write? Yes. If you are not using these default settings, make the appropriate System Setup? changes before you use
	your Orbit II System.
!!WARNING!! Copier	Your Orbit II System Setup has been changed to Burn CD? No. If you want to proceed with the operation you selected
is in SIMULATE mode	press the Yes key. If you do not want to proceed in simulate mode, press the No key and change the System Setup?.

37