Installation
Levelling the appliance | Room ventilation |
Turn the 4 screw feet to adjust the dryer to the correct height and level.
Longer screw feet are available as an optional accessory. Unscrew and remove the feet supplied with the appliance before fitting the longer screw feet.
The cover plate on the dryer must be aligned horizontally underneath the worktop.
The ventilation gaps in the plinth must not be covered over. This would hinder a sufficient flow of air to the dryer.
Air taken in for use in the drying process will be warm when it is expelled from underneath the dryer. This expelled air heats up the air in the room. It is therefore very important to ensure that the room is adequately ventilated, particularly if the dryer is located in a small room. Otherwise running times and energy consumption could be increased.
Washer-dryer stack
The tumble dryer can also be combined with a Miele washing machine in a
The stacking kit must be fitted by a suitably qualified fitter.
Before moving the tumble dryer again (e.g. when moving house)
After each use a small quantity of condensed water will collect in the area around the pump. This water can run out if the dryer is tipped up when it is being moved. It is therefore a good idea to run the Cool air programme for approximately 1 minute before moving it. Any remaining condensed water will then be fed into the condensed water container or out through the drain hose.
43
