Installation
For right hand hinging only:
–front panel shown decor side face down, upper edge at the bottom:
if width (b) increases, measurement a must also be increased
b = 592 mm a = 21.5 mm b = 593 mm a = 22.0 mm b = 594 mm a = 22.5 mm b = 595 mm a = 23.0 mm b = 596 mm a = 23.5 mm
H = height of adjacent furniture unit doors.
Drill the two hinge holes ( 35 mm/15.5 mm deep) in the back of the front panel.
Next, drill the four smaller holes
( 7 mm/10 mm deep) in the back of the front panel.
Shorten the front panel from the bottom to height H.
Preparing the fixing points
Hold the
Mark the fixing points on the back of the front panel through the holes in the machine door plate (see arrows in the illustration).
Remove the front panel.
Now drill holes ( 2.5 mm/10 mm deep) in the back of the front panel.
47
