Programmable functions
Adjusting the dryer's electronics for very soft water
In some areas of the UK, water is extremely soft which can affect the sensitivity of the control electronics. If the dryer is installed in an area of very soft water, you should contact your local water supplier for information and advice regarding water hardness and water conductivity. If the water conductivity is less than 150 µS, the following programmable function will need to be activated.
Important. This programmable function should not be activated if, despite the water being extremely soft (as would be the case if a water softener were used), its conductivity is greater than 150 µS.
Follow the steps (,, ...) to programme and store in memory.
Before you begin, ensure that:
–The tumble dryer is switched off.
–The door is closed.
Press the Start/Stop button and keep it pressed in whilst carrying out steps
Switch the dryer on.
Wait until the Start/Stop button lights up constantly . . .
. . . and then release the Start/Stop button.
Press the Low temperature button ten times.
–The Low temperature indicator light will flash on and off slowly once and then on and off quickly twice.
A number to show which option is selected will appear in the display alternating with the letter P.
0Factory default setting
IAdjusted for very soft water
(the Automatic plus indicator light will also flash)
Pressing the Start/Stop button switches between the options.
Switch the dryer off.
The setting you have selected is now stored in memory. You can change it again at any time.
To check the setting:
Carry out steps to .
Switch the dryer off after step .
66
