Intel 8S661FXM-RZ user manual Sysfan System FAN Connector, FDD Floppy Connector

Page 15

4) SYS_FAN (System FAN Connector)

This connector allows you to link with the cooling fan on the system case to lower the system temperature.

	Pin No.	Definition
1	1	GND
1	2	+12V
	3	Sense

5) FDD (Floppy Connector)

Please connect the floppy drive ribbon cables to FDD. It supports 360K,720K,1.2M,1.44M and 2.88Mbytes floppy disk types.

The red stripe of the ribbon cable must be the same side with the Pin1.

34 33

2 1

6) IDE1/ IDE2(IDE1/IDE2 Connector)

Please connect first harddisk to IDE1 and connect CDROM to IDE2.

The red stripe of the ribbon cable must be the same side with the Pin1.

4039

21

IDE2 IDE1

English

- 15 -

Hardware Installation Process

Image 15

Contents 8S661FXM-RZ Motherboard 8S661FXM-RZ Preparing Your Computer Installing the motherboard to the chassisTable of Content Introduction Features SummaryEnglish 8S661FXM-RZ 8S661FXM-RZ Motherboard LayoutBlock Diagram Step Hardware Installation ProcessCPU Installation DDR Install memory modulesInstall I/O Peripherals Cables Install expansion cardsCdin ATX12VFDD IDE1 / IDE2 BATATX12V +12V Power Connector ATX ATX PowerCpufan CPU FAN Connector Sysfan System FAN Connector FDD Floppy ConnectorIDE1/ IDE2IDE1/IDE2 Connector Fpanel 2x10 pins connector Faudio Faudio Connector BAT BatterySpdifio Spdif In/Out USB1 / FUSB2 Front USB Connector Comb COM B ConnectorClrcmos Clear Cmos CI Chassis Intrusion, Case Open Main Menu Main Menu For example Bios Ver. F8cEntering Bios Setup Status Page Setup Menu / Option Page Setup MenuLoad Fail-Safe Defaults Advanced Bios FeaturesPower Management Setup PnP/PCI ConfigurationIDE Primary Master, Slave / IDE Secondary Master, Slave Standard Cmos FeaturesDate TimeMemory Floppy 3 Mode Support for Japan AreaDrive a / Drive B Halt onAdvanced Bios Features First / Second / Third Boot DeviceBoot Up Floppy Seek Password Check CPU Hyper-ThreadingInit Display First Integrated Peripherals USB Controller Parallel Port ModeECP Mode Use DMA Onboard LAN devicePower Management Setup System after AC Back Power On by KeyboardPower On by Mouse Resume by AlarmPCI 3 IRQ Assignment PnP/PCI ConfigurationsPCI 1 IRQ Assignment PCI 2 IRQ AssignmentPC Health Status MB Intelligent Tweaker M.I.T Top Performance Load Fail-Safe Defaults Load Optimized DefaultsSet Supervisor/User Password Exit Without Saving Save & Exit SetupPictures below are shown in Windows XP Install DriversItem Description English Contact US