Intel Official Manual for 845GL: Connectors and CPU Installation Guide

Page 6

Connectors

PS/2 (Bottom)

 

PS/2 Keyboard (Down Purple)

PS/2 (Top)

 

PS/2 Mouse Header (Up Green)

USB 0/1

 

USB 0/1 Connector Port

USB 2/3

 

USB 2/3 Connector Port

LPT

 

Printer Connector Port

VGA

 

VGA Display Connector Port

COM1

 

Serial Ports COM1 Connector Port

GAME/MIDI

 

Game/MIDI Port

LINE OUT/LINE IN/MIC

 

Audio Output/Audio Input/Microphone

CD_IN

 

CD-ROM Audio Input Port

IDE1/IDE2

 

Primary IDE/Secondary IDE Port

FDD

 

Floppy Disk Drive Connector Port

PW1

 

ATX_20 Power Supply Connector Port

PW2

 

ATX_4 Power Supply Connector Port

FAN ½

 

CPU System Fan Port

IrDA

 

IrDA Infrared Port

Function Port Pane1

 

 

 

 

 

 

Power Supply LED

Pin 1:Power Supply Anode; Pin 3: Ground

 

 

 

HDD LED

Pin 2: Power Supply Anode; Pin 4: LED Signal

 

 

 

ATX Power Supply Switch

Pin 8: Switch Signal; Pin 10: Power Supply

 

Anode

 

Reset Switch

Pin 14: Ground; Pin 16:Reset Signal

 

 

 

 

Speaker Input

Pin 9: Speaker Audio Input; Pin 15 : Power

 

Supply Anode

 

4.2 CPU Installation

 

 

 

This main board has a socket 478 processor socket. Follow these instructions to install the CPU:

1.Unhook the CPU socket’s locking lever pulling it away from socket and raising it to the upright position.

2.Match the pin 1 corner of CPU socket to the one of processor, and insert the processor into the socket. Do not use force.

3.Push the locking lever down and hook it under the latch on the edge of socket.

4.Apply thermal grease to the top of the CPU.

5.Lower the CPU fan/heat sink unit onto the CPU and CPU socket, and then use the retention module clamps to snap the fan/heat sink into place.

6.Plug the CPU fan power cable into the CPU cooling fan power supply connector on the main board.

Image 6
Contents Bios SETUP………………………………………………… Package CONTENTS………………….…………………INSTALLATION…………………………….……………… INTRODUCTION……………………….…………………Introduction Package ContentsKey Features -Chipset ProcessorIDE Port Bios SupportsUSB Ports Six USB ports PortsMain board Locations USB Expansion Connector JP3 Clear Cmos Jumper SettingAudio Front panel Jumper setting Expansion SlotsConnectors CPU InstallationFunction Port Pane1 Page Memory installation IDE Devices InstallationATX Power connectors 20-pin ATXPWRI, 4-pin ATX Other Device Installation Floppy Disk Drive InstallationSound Connector Port Installation Wake on LAN WOLDriver Installation Installation Directory Intel Chipset Software SetupClick Next to continue Select YES to continue Page Page Select Next to continue Select Next to Continue Select Finish to complete the installation Windows 98se driver setup Channel Sound Output SupportPage Select Reinstall Driver to continue Select Next to continue Page Select Next to continue Select Next to Continue Select Next to Continue Page Bios Setup Main menuStandard Cmos Features Advanced Bios FeaturesAdvanced Chipset Features Integrated PeripheralsPower Management Setup PnP/PCI ConfigurationsChange Password Load Fail-Safe DefaultsLoad Optimized Defaults Save Exit & Without Save Exit Setup