ZONE 2 REMOTE CONTROL FUNCTIONS
The Zone 2 remote control is used in the remote zone of a multizone system with an IR receiver connected to the Zone 2 IR Input or an
The Zone 2 remote may also be used in the main listening room to directly control the AVR 7550HD and Harman Kardon DVD, CD or tape players. When the Zone Selector is pressed to switch the remote to Zone 1 mode (the Zone Indicator will turn green), the power, volume and mute controls will only affect the main listening area. To control operation for the remote zone, press the Zone Selector so that the Zone Indicator turns red.
The Zone 2 remote requires two AAA batteries (included) that are installed in the battery compartment on the back of the remote. Make sure to observe proper polarity by matching the + and – symbols on the batteries to the symbols printed inside the compartment.
IR Transmitter: This lens emits infrared codes when buttons on the remote are pressed.
Power: Press to turn the AVR 7550HD on or off. The AVR also turns on its multizone system automatically when any of the Input Selectors is pressed, even if the AVR itself is in Standby mode. When in the main listening room, press any Input Selector or the AVR Selector to turn on the AVR 7550HD.
Mute: Press to mute the AVR 7550HD’s remote zone speakers temporarily. To end the muting, press this button, adjust the volume, or turn off the multizone system. Make sure to switch the remote to Zone 2 mode, so that only the remote zone will be affected.
Source Selectors: Press one of these buttons to select a source device for the remote zone. It will also turn on the multizone system and switch the remote to the source’s device mode. You may select a different external source device than that for the main room, but not different internal sources (the tuner, USB, Internet Radio or the Network). If you select the same source as that for the main room, then any commands sent to the source will affect both zones. The first press of the Radio Selector switches the AVR to the
Transport Controls: These buttons are used to control many source components.
AVR Settings Button: Press to display the AVR’s Main Menu. It is also used to switch the remote to AVR device mode.
Sleep Settings Button: Press to activate the sleep timer, which turns off the receiver after a programmed period of time of up to 90 minutes. Each additional press decreases the timer by 10 minutes, ending with the “Sleep Off” message.
Back/Exit: Press to return to the previous menu or to exit the menu system.
Menu Button: This button is used within the Now Playing menu for the tuner (including XM Radio), USB, The Bridge II, Internet Radio and the Network, and to display the main menu on some source devices. To display the AVR 7550HD’s main menu, press the AVR Settings Button.
Navigation (1/57/3) and OK Buttons: These buttons are used to make selections within the menu system and also to operate the tuner, USB, The Bridge II, Internet Radio and the Network device.
Zone Selector and Zone Indicator: Each press of the Zone Selector determines whether the AVR commands will affect the main listening area (Zone 1) or the remote zone (Zone 2). The Zone Indicator will turn green when Zone 1 has been selected, and red for Zone 2. The Zone Indicator will also light briefly when- ever any button is pressed.
Volume Controls: Press to raise or lower the volume level in the remote zone.
16
