ViewSonic NMP-530 manual Appendix, Compliance and Safety Notices

Page 39

APPENDIX

COMPLIANCE AND SAFETY NOTICES

FCC CLASS B COMPLIANCE NOTICE (UNITED STATES)

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at user’s own expense.

You can determine whether your equipment is causing interference by turning it off. If the interference stops, it was probably caused by this equipment or one of its peripheral devices. If the equipment causes interference to radio or television reception, try to correct the interference by using one or more of the following measures:

Turn the television or radio antenna until the interference stops.

Move the equipment to one side or the other of the television or radio.

Move the equipment farther away from the television or radio.

Plug the equipment into an outlet that is on a different circuit from the television or radio. (That is, make certain the equipment and the television or radios are on circuits controlled by different circuit breakers or fuses.)

Modifying the equipment without proper authorization may result in the equipment no longer complying with FCC requirements for Class A or Class B digital devices. In that event, your right to use the equipment may be limited by FCC regulations, and you may be required to correct any interference to radio or television communications at your own expense.

E N G L I S H

ViewSonic NMP-530

33

Image 39
Contents NMP-530 This page is blank for dual-sided printing Product Registration ViewSonic NMP-530 Contents Help Introduction Packaged ContentsRequirements FeaturesStandalone TWO Modes of OperationRemote Control Front ViewBack View Connect to a Display SetupConnect to a Router Turn Power on IP Address LoginStart URL Hdmi SET Video Output of NMP-530PUT Batteries in Remote Control Management Startup URLS/NETWORK ConfigurationBrowser Configuration ViewSonic NMP-530 VIDEO/AUDIO Configuration TAS Configuration FTP Server System Services Configuration Video UDP Multicast ActionsVideo RTP Multicast Video Http Video File Playing Content from Local StorageVideo Iptv To Create a Playlist PlaylistTransparency GO to URL Advanced Video Configuration AdministrationSecurity Default Settings Save Configuration Firmware Upgrade RebootStatus HelpAbout LicenseAppendix Compliance and Safety NoticesCanadian compliance notice For EU-member states only as follows Screens Actions Administration Help Fax Customer SupportCvbx SpecificationsLimited Warranty