Configuring TCP/IP
The SBV5121 VoIP cable modem contains all required software. You do not need to configure the VoIP cable modem, but you must be sure that your computer is configured for TCP/IP (a protocol for communication between computers). Perform one of the following:
•
•
•
•
“Configuring TCP/IP in Windows 98 Second Edition, or Windows Me” on page 20
“Configuring TCP/IP in Windows 2000” on page 23
“Configuring TCP/IP in Windows XP” on page 26
Follow the instructions in your Macintosh or UNIX user manual
After configuring TCP/IP, perform one of the following to verify the IP address:
•
•
•
“Verifying the IP Address in Windows 98 Second Edition, or Windows Me” on page 30
“Verifying the IP Address in Windows 2000 or Windows XP” on page 31
Follow the instructions in your Macintosh or UNIX user manual
Your cable provider may provide additional instructions to set up your computer.
Configuring TCP/IP in Windows 98 Second Edition, or Windows Me
1On the Windows Desktop, click Start.
2Select Settings and then Control Panel from the
3
4Select the Configuration tab.
5Verify that TCP/IP is installed for the adapter that will be used to connect to the VoIP cable modem by looking for TCP/IP. If found, TCP/IP is installed. Skip to step 10. If TCP/IP is not installed for the adapter, continue with step 6.
SBV5121 VoIP Cable Modem User Guide | 20 |