Partner Tech EM200PR, EM200WIN7 user manual Upgrading the hard drive

Page 31

Upgrading the hard drive

Refer to the following to remove and replace the hard drive.

1. Turn off the EM-200.

2. Disconnect the AC adapter cable.

3. Overturn the EM200.

4. Remove the two screws as shown in the right.

5. Open and remove the hard drive compartment cover.

6. Slide the hard drive to disconnect.

25

Image 31

Contents EM-200 Page Federal Communications Commission FCC CopyrightDisclaimer Trademark recognitionAbout this manual Safety informationRevision history Table of Contents Unpacking the machine Chapter Getting StartedQSG Checking the package contentsFront view Identifying componentsLeft view Right view Rear view Bottom view Installing the battery pack Charging the battery pack Powering on Using the USB keyboard About the Setup UtilityBios Navigation Keys Entering the Setup UtilityUsing Bios Main Menu Advanced S3 Advanced MenuKeyboard Language Numlock Boot ConfigurationHDC Configure as IDE ConfigurationATA/IDE Mode Channel 1 Master Channel 1 MasterType User Access Level Supervisor/ User PasswordSet Supervisor and User Passwords Power on passwordQuiet Boot Boot MenuBoot Type Order Boot Device PriorityExit Discarding Changes Load Optimal DefaultsExit Menu Exit Saving ChangesChapter Upgrading Components Safety and precautionsBefore you begin Upgrading the hard drive H a P T E R 3 U P G R a D I N G C O M P O N E N T S Upgrading the memory module Upgrading the Mini-PCIE card Locate the Mini-PCIE card, as shown in the right H a P T E R 3 U P G R a D I N G C O M P O N E N T S Tips for Troubleshooting TroubleshootingProblem Solution General ProblemsHaving the EM-200 Serviced Bios Specification