Partner Tech EM200WIN7, EM200PR user manual About this manual, Safety information

Page 4

About this manual

This manual is intended for system administrators who are familiar with setting up a new system and installing an operating system.

The manual consists of the following sections:

Chapter 1 Getting Started:

This section covers unpacking and checking the

 

package contents, identifying components, installing the

 

battery pack, charging the battery and powering on.

Chapter 2 BIOS Setup Utility:

The BIOS chapter provides information on navigating

 

and changing settings in the BIOS Setup Utility.

Chapter 3 Upgrading Components:

This section provides information on upgrading

 

components.

Appendix:

The appendix covers troubleshooting, information

 

on having the EM-200 serviced, and technical

 

specifications.

Safety information

Before installing and using the EM-200, take note of the following precautions:

Read all instructions carefully.

SAR compliance for body-worn operations is restricted which provide at least 2 cm separation between the device and the user’s body

Do not place the unit on an unstable surface, cart, or stand.

Do not block the slots and opening on the unit, which are provided for ventilation.

Do not push objects in the ventilation slots as they may touch high voltage components and result in shock and damage to the components.

Do not place anything on the power cord. Place the power cord where it will not be in the way of foot traffic.

Follow all warnings and cautions in this manual and on the unit case.

When replacing parts, ensure that your service technician uses parts specified by the manufacturer.

Avoid using the system near water, in direct sunlight, or near a heating device.

Never throw the battery into a fire or put it near a fire.

WARNING

警告

注意

Warning! Batteries may explode if not handled properly. Do not disas- semble or dispose of them in fire. Keep them away from children. Follow local regulations when disposing of used batteries.

不正確地更換電池會有爆炸的危險。僅可更換為廠商建議的相同電池或相同型 式電池。請依據廠商說明書棄置電池。

用错误型号电池更换会有爆炸危险务必按照说明处置用完的电池。

ii

Image 4
Contents EM-200 Page Copyright DisclaimerTrademark recognition Federal Communications Commission FCCSafety information About this manualRevision history Table of Contents Chapter Getting Started Unpacking the machineChecking the package contents QSGIdentifying components Front viewLeft view Right view Rear view Bottom view Installing the battery pack Charging the battery pack Powering on About the Setup Utility Using the USB keyboardEntering the Setup Utility Bios Navigation KeysUsing Bios Main Menu Advanced S3 Advanced MenuKeyboard Language Boot Configuration NumlockHDC Configure as IDE ConfigurationATA/IDE Mode Channel 1 Master Channel 1 MasterType Supervisor/ User Password Set Supervisor and User PasswordsPower on password User Access LevelBoot Menu Quiet BootBoot Device Priority Boot Type OrderLoad Optimal Defaults Exit MenuExit Saving Changes Exit Discarding ChangesSafety and precautions Chapter Upgrading ComponentsBefore you begin Upgrading the hard drive H a P T E R 3 U P G R a D I N G C O M P O N E N T S Upgrading the memory module Upgrading the Mini-PCIE card Locate the Mini-PCIE card, as shown in the right H a P T E R 3 U P G R a D I N G C O M P O N E N T S Troubleshooting Tips for TroubleshootingGeneral Problems Problem SolutionHaving the EM-200 Serviced Specification Bios