Lenovo Q180 manual Replacing hardware, General information, Pre-disassembly instructions

Page 31

Chapter 8. Replacing hardware

Attention: Do not remove the computer cover or attempt any repair before reading the “Important safety information” in the Safety and Warranty Guide that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or HMM, go to the Support Web site at: http://consumersupport.lenovo.com.

Note: Use only parts provided by Lenovo.

General information

Pre-disassembly instructions

Before proceeding with the disassembly procedure, make sure that you do the following:

1.Turn off the power to the system and all peripherals.

2.Unplug all power and signal cables from the computer.

3.Place the system on a flat, stable surface.

© Copyright Lenovo 2011

25

Image 31

Contents IdeaCentre Q180 Hardware Maintenance Manual Page IdeaCentre Q180 Hardware Maintenance Manual Page Contents Iv IdeaCentre Q180Hardware Maintenance Manual About this manual Important Safety InformationIdeaCentre Q180Hardware Maintenance Manual General safety Safety informationElectrical safety IdeaCentre Q180Hardware Maintenance Manual Handling electrostatic discharge-sensitive devices Safety inspection guideGrounding requirements Safety noticesTo Connect To Disconnect Do not≥18 kg37 lbs ≥32 kg70.5 lbs ≥55 kg121.2 lbs Environment SpecificationsGeneral information Type IdeaCentre Q180IdeaCentre Q180Hardware Maintenance Manual General Checkout IdeaCentre Q180Hardware Maintenance Manual Using passwords Using the Setup UtilityStarting the Setup Utility program Viewing and changing settingsSetting, changing, or deleting an Administrator password Administrator PasswordSetting, changing, or deleting a Power-On Password Select Save changes and Exit from the menu Enabling or disabling a deviceSelecting or changing the startup device sequence Exiting the Setup Utility programSelecting a startup device Selecting a temporary startup deviceUsing the Setup Utility IdeaCentre Q180Hardware Maintenance Manual Error FRU/Action Symptom-to-FRU IndexHard disk drive boot error Power Supply ProblemsUndetermined problems Post error codesPost Error Message Description/Action Locations Locating components, controls and connectorsFront view Rear view Hardware components Identifying parts on the motherboard Replacing hardware Pre-disassembly instructionsGeneral information To replace the optical drive Replacing the optical driveTo remove the computer cover Removing the computer coverTo replace the hard disk drive Replacing the hard disk driveTo replace a memory module Replacing a memory moduleTo replace the Wlan card Removing the power buttonTo remove the power button Replacing the Wlan cardTo replace the CPU heatsink and system fan Replacing the CPU heatsink and system fanTo replace the motherboard Replacing the motherboardTo replace the keyboard and mouse Replacing the keyboard and mouseItem # FRUs FRU listsComputer Cover Q180 TOP case module 110200358 Motherboard Hard disk drivesWlan card Memory moduleChassis Power buttonSystem fan and heatsink Automatic Power-On features Additional Service InformationPower management Advanced configuration and power interface Acpi Bios